NUMBER
GS-12-1195
TITLE
TYPE
PRODUCT SPECIFICATION
M.2 connector
PAGE
REVISION
5 of 7
C
AUTHORIZED BY
Kenny Tai
DATE
2014/11/19
CLASSIFICATION
UNRESTRICTED
C Environmental Requirement
ITEM
Test Item
Requirements
13
Resistance to Reflow
Soldering Heat
No physical damage shall occur.
(Lead-Free)
(See Note 2)
14 Thermal shock
See Note 1
15 Thermal Disturbance See Note 1
16 Thermal Cycling
See Note 1
17 Humidity
See Note 1
18 Temperature Life
See Note 1
Procedure
Pre Heat:150~180℃, 90±30sec.
Heat:230℃ Min., 30±10sec.
Peak Temp.:260+0/-5℃, 10sec.
Duration:3 cycles
Mated Connectors
-55+/-3℃ (30 min.), +85+/-2℃ (30 min.)
Perform this cycle, repeat 5 cycles
(EIA-364-32)
Mated connectors
Cycle the connector between -15℃+/-3℃
and 85℃+/-3℃. Ramps should be 1℃ min.
per minute, and dwell times should ensure
the contacts reach the temperature
extremes (5 minutes min.). Humidity is not
controlled. Perform 10 such cycles.
Cycle the connector between -15℃+/-3℃
and 85℃+/-3℃. Ramps should be 1℃ min.
per minute, and dwell times should ensure
the contacts reach the temperature
extremes (5 minutes min.). Humidity is not
controlled. Perform 500 such cycles.
Subject mated Connectors to 96 hours at
40℃ with 90~95% RH.
(EIA-364-31 Method II Test Condition A.)
Mated Connector 90℃, 288 hours,
(EIA-364-17 Method A.)
19 Salt Spray
No detrimental corrosion allowed
in contact area and base metal
exposed.
Subject mated connectors to 35+/-2 ℃ and
5+/-1% salt condition for 24hours. After
test, rinse the sample with water and
recondition the room temperature for 1
hour. (EIA-364-26B)
Note 1:Shall meet visual requirements, show no physical damage, and meet requirement of additional tests as
specified in the test sequence.
Note 2:Resistance to soldering process is indicated on notes of customer drawing. Select the appropriate test
type which drawing notes are matched with.
Copyright FCI.
Form E-3701 – Revision C
PDS: Rev :C
GS-01-029
STATUS:Released
Printed: Jan 16, 2015