Sensing and Control
Photologic® Optically
Coupled Isolator
OPI127-032
Features:
ï‚·ï€ Four output op ons
ï‚·ï€ 15 kV inputâ€toâ€output isola on voltage
ï‚·ï€ Direct TTL/STTL interface
ï‚·ï€ High noise immunity
ï‚·ï€ Data rates to 250 KBit/s
ï‚·ï€ Herme cally sealed
ï‚·ï€ UL File No. E 58730*
Descrip on:
The OPI127â€032 consists of an op cally coupled isolator with a gallium arsenide infrared emi ng diode coupled to a
monolithic integrated circuit. This circuit incorporates a photodiode, a linear ampliï¬er and a Schmi trigger on a single
silicon chip. For maximum longâ€term stability, both the diode and the Photologic® sensor are herme cally sealed in
separate packages and then mounted in a high dielectric plas c housing.
This device features TTL/LSTTL compa ble logic level output that can drive up to 8 TTL loads directly without addi onal
circuitry. Also featured are mediumâ€speed data rates to 250 KBit/s, with typical rise and fall mes of 70 nanoseconds. *UL
recogni on is for 15KVDC to 100° C.
For more informa on, contact your local representa ve or OPTEK.
Applica ons:
ï‚·ï€ High voltage isolation
between input and output
ï‚·ï€ Electrical isolation in dirty
environments
ï‚·ï€ Industrial equipment
ï‚·ï€ Medical equipment
ï‚·ï€ Office equipment
Part Number
LED Peak
Wavelength
OPI127â€032
890nm
Ordering Informa on
Sensor
Photologic®
Isola on
Voltage
(,000)
tPLH / tPHL
Typ (µs)
Inverted Totem
Pole
15
5/5
IF (mA)
Typ / Max
7.5 / 25
VCE
(Volts)
Max
35.0
Lead
Length /
Spacing
0.40" /
0.75"
*Length
1.26â€
[32mm]
Pin #
1
2
LED
Anode
Cathode
Pin #
5
4
3
Photologic®
Output
Vcc
Ground
RoHS
General Note
TT Electronics reserves the right to make changes in product speciï¬ca on
without no ce or liability. All informa on is subject to TT Electronics’ own data
and is considered accurate at me of going to print.
© TT electronics plc
1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200
www.optekinc.com | www. electronics.com
Issue E.1 06/2016 Page 1