X25128PF View Datasheet(PDF) - Xicor -> Intersil

Part Name

Description

Manufacturer

X25128PF

SPI Serial E²PROM with Block Lock™ Protection

Xicor -> Intersil 

X25128

ABSOLUTE MAXIMUM RATINGS*

Temperature under Bias ................... –65°C to +135°C

Storage Temperature........................ –65°C to +150°C

Voltage on any Pin with

Respect to VSS.................................... –1V to +7V

D.C. Output Current ..............................................5mA

Lead Temperature

(Soldering, 10 seconds) .............................. 300°C

RECOMMENDED OPERATING CONDITIONS

*COMMENT

Stresses above those listed under “Absolute Maximum

Ratings” may cause permanent damage to the device.

This is a stress rating only and the functional operation

of the device at these or any other conditions above

those indicated in the operational sections of this

specification is not implied. Exposure to absolute

maximum rating conditions for extended periods may

affect device reliability.

Temperature

Commercial

Industrial

Military

Min.

0°C

–40°C

–55°C

Max.

+70°C

+85°C

+125°C

3091 FM T06.1

Supply Voltage

X25128

X25128-2.7

Limits

5V ±10%

2.5V to 5.5V

3091 FM T07.2

D.C. OPERATING CHARACTERISTICS

Limits

Symbol

Parameter

ICC

VCC Supply Current (Active)

ISB

ILI

ILO

VlL(1)

VIH(1)

VOL1

VOH1

VOL2

VOH2

VCC Supply Current (Standby)

Input Leakage Current

Output Leakage Current

Input LOW Voltage

Input HIGH Voltage

Output LOW Voltage

Output HIGH Voltage

Output LOW Voltage

Output HIGH Voltage

Min.

–1

VCC x 0.7

VCC – 0.8

VCC – 0.3

Max. Units

Test Conditions

5

1

10

10

VCC x 0.3

VCC + 0.5

0.4

0.4

mA SCK = VCC x 0.1/VCC x 0.9 @ 2 MHz,

SO = Open, CS = VSS

µA CS = VCC, VIN = VSS or VCC

µA VIN = VSS to VCC

µA VOUT = VSS to VCC

V

V

V VCC = 5V, IOL = 3mA

V VCC = 5V, IOH = -1.6mA

V VCC = 3V, IOL = 1.5mA

V VCC = 3V, IOH = -0.4mA

POWER-UP TIMING

Symbol

tPUR(3)

tPUW(3)

Parameter

Power-up to Read Operation

Power-up to Write Operation

CAPACITANCE TA = +25°C, f = 1MHz, VCC = 5V

Min.

Max.

1

5

Units

ms

ms

3091 FM T09

Symbol

Test

Max.

Units

Conditions

COUT(2)

CIN(2)

Output Capacitance (SO)

Input Capacitance (SCK, SI, CS, WP, HOLD)

8

pF

6

pF

VOUT = 0V

VIN = 0V

Notes: (1) VIL min. and VIH max. are for reference only and are not tested.

(2) This parameter is periodically sampled and not 100% tested.

(3) tPUR and tPUW are the delays required from the time VCC is stable until the specified operation can be initiated. These

parameters are periodically sampled and not 100% tested.

3091 FM T10.1

8

Share Link: