AGL1000V2-QNG144I View Datasheet(PDF) - Microsemi Corporation

Part Name

Description

Manufacturer

AGL1000V2-QNG144I

IGLOO Low Power Flash FPGAs with Flash* Freeze Technology

Microsemi Corporation 

2 – IGLOO DC and Switching Characteristics

General Specifications

Operating Conditions

Stresses beyond those listed in Table 2-1 may cause permanent damage to the device.

Exposure to absolute maximum rating conditions for extended periods may affect device reliability.

Absolute Maximum Ratings are stress ratings only; functional operation of the device at these or any

other conditions beyond those listed under the Recommended Operating Conditions specified in Table 2-

2 on page 2-2 is not implied.

Table 2-1 • Absolute Maximum Ratings

Symbol

Parameter

Limits1

Units

VCC

DC core supply voltage

–0.3 to 1.65

V

VJTAG

JTAG DC voltage

–0.3 to 3.75

V

VPUMP

Programming voltage

–0.3 to 3.75

V

VCCPLL

Analog power supply (PLL)

–0.3 to 1.65

V

VCCI and VMV 2 DC I/O buffer supply voltage

–0.3 to 3.75

V

VI

I/O input voltage

–0.3 V to 3.6 V (when I/O hot insertion mode is enabled) V

–0.3 V to (VCCI + 1 V) or 3.6 V, whichever voltage is lower

(when I/O hot-insertion mode is disabled)

TSTG 3

TJ 3

Storage Temperature

Junction Temperature

–65 to +150

°C

+125

°C

Notes:

1. The device should be operated within the limits specified by the datasheet. During transitions, the input signal may

undershoot or overshoot according to the limits shown in Table 2-4 on page 2-3.

2. VMV pins must be connected to the corresponding VCCI pins. See the "Pin Descriptions" chapter of the IGLOO FPGA

Fabric User’s Guide for further information.

3. For flash programming and retention, maximum limits refer to Table 2-3 on page 2-2, and for recommended operating

limits, refer to Table 2-2 on page 2-2.

Revision 23

2-1

Share Link: