ELECTRICAL CHARACTERISTICS
STATIC ELECTRICAL CHARACTERISTICS
Table 3. Static Electrical Characteristics (continued)
Characteristics noted under conditions 3.0 V ≤ VCC ≤ 5.5 V, 7.0 V ≤ VBAT ≤ 20 V, -40 °C ≤ TA ≤ 125 °C, unless otherwise noted.
Typical values noted reflect the approximate parameter mean at TA = 25 °C under nominal conditions, unless otherwise noted.
Characteristic
Symbol
Min
Typ
Max Unit
LOGIC INPUT/ OUTPUT (IGN, CS, CSNS, SI, SCLK, CLOCK, SO, FLASHER, RST, LIMP, STOP) (CONTINUED)
CLOCK Output Voltage reporting wake-up event (ICLOCK=1.0 mA)
SO Low-state Output Voltage
IOL = -1.6 mA
VCLOCKH
VSOL
0.8
0.95
–
VCC
–
0.2
0.4
V
SO Tri-state Leakage Current
CS > 0.7 VCC
ISOLEAK
- 1.0
0.0
1.0
μA
CSNS Tri-state Leakage Current
VCC = 5.5 V, CSNS = 5.5 V
VCC = 5.0 V, CSNS = 5.5 V
VCC = 5.0 V, CSNS = 4.5 V
ICSNSLEAK
- 5.0
0
- 10
0
- 1.0
0
μA
1.0
1.0
1.0
Current Sense Output Clamp Voltage
ICSNS < 10.0 mA
VCSNS
5.0
6.0
7.0
V
OUTPUT (OUT 1:5)
Output Leakage Current in OFF state
Sleep mode, Outputs Grounded
Normal mode, Outputs Grounded
IOUTLEAK
μA
–
0
2.0
–
20
25
Output Negative Clamp Voltage
IOUT = -500 mA, Outputs OFF
Current Sense Output Precision(9)
Full-Scale Range (FSR) for LED Control bit = 0
0.75 FSR
0.50 FSR
0.25 FSR
0.10 FSR
Full-Scale Range (FSR) for LED Control bit = 1
0.187 FSR = 0.75 FSRLED
0.125 FSR = 0.50 FSRLED
0.062 FSR = 0.25 FSRLED
0.025 FSR = 0.10 FSRLED
VOUT
δICS / ICS
- 22
–
-16
V
-14
-
-15
-
-17
-
-22
-
-13
-
-13
-
-20
-
-30
-
%
14
15
17
22
13
13
20
30
Current Sense Output Precision
Over-temperature Range [-40;125 °C], VBAT Range [10 V-16 V] and FSR
Range [25%-100%], calculated with one calibration point (Taken at 25 °C,
VBAT = 13.5 V and 50% FSR)(11)
-6.0
-
6.0
%
Current Sense Output Precision with one calibration point (50% FSRLED,
-6.0
VBAT = 13.5 at 25 °C(11)
Temperature Drift of Current Sense Output(10)
ΔICS / ΔT
–
VBAT = 13.5 V, IOUT = 2.8 A reference taken at TA = 25 °C
Minimum Output Current Reported in CSNS for OUT[1-5](12)
10 V ≤ VBAT ≤ 16 V
I35MIN(CSNS)
65
Minimum Output Current Reported in CSNS for OUT[1-5] in LED Mode(12) I35MIN(CSNS) LED
10 V ≤ VBAT ≤ 16 V
40
–
± 280
–
–
6.0
%
± 400
–
–
ppm/
°C
mA
mA
Notes
9. 10 V < VBAT < 16 V. (δICS/ICS = (measured ICS- targeted ICS)/ targeted ICS with targeted ICS = 5.0 mA
10. Based on statistical data. Not production tested. ΔICS/ΔT = [(measured at ICS at T1 - measured at ICS at T2) measured at ICS at room]/
(T1 - T2)
11. Based on statistical analysis covering 99.74% of parts.
12. Output current value computed after leakage current removal (open load condition)
Analog Integrated Circuit Device Data
Freescale Semiconductor
35XS3500
7