HI-8585CDI View Datasheet(PDF) - Holt Integrated Circuits
Part Name
Description
Manufacturer
HI-8585CDI Datasheet PDF : 8 Pages
| |||
HI-8585, HI-8586
ABSOLUTE MAXIMUM RATINGS
RECOMMENDED OPERATING CONDITIONS
Voltages referenced to Ground
Supply voltages
V+....................................................20V
V-....................................................-20V
DC current per input pin................ +10mA
Power dissipation at 25°C
plastic DIL............1.0W, derate 10mW/°C
ceramic DIL..........0.5W, derate 7mW/°C
Solder Temperature ........275°C for 10 sec
Storage Temperature........-65°C to +150°C
Supply Voltages
V+....................+12V ± 5% or +15V ±10%
V-..................... -12V ± 5% or -15V ±10%
Temperature Range
Industrial Screening.........-40°C to +85°C
Hi-Temp Screening........-55°C to +125°C
Military Screening..........-55°C to +125°C
NOTE: Stresses above absolute maximum
ratings or outside recommended operating
conditions may cause permanent damage to
the device. These are stress ratings only.
Operation at the limits is not recommended.
DC ELECTRICAL CHARACTERISTICS
V+ = +12V to +15V, V- = -12V to -15V, TA = Operating Temperature Range (unless otherwise stated)
PARAMETERS
SYMBOL TEST CONDITIONS
MIN TYP MAX UNITS
Input voltage (TX1IN, TX0IN, SLP1.5)
high
VIH
low
VIL
2.1
-
V+ volts
-
-
0.5 volts
Input current (TX1IN, TX0IN, SLP1.5)
source
IIH
VIN = 0V
sink
IIL
VIN = 5V
-
-
0.1 µA
-
-
0.1 µA
ARINC output voltage (Differential)
one
zero
null
VDIFF1
VDIFF0
VDIFFN
no load; TXAOUT - TXBOUT 9.00 10.00 11.00
no load; TXAOUT - TXBOUT -11.00 -10.00 -9.00
no load; TXAOUT - TXBOUT -0.50 0 0.50
volts
volts
volts
ARINC output voltage (Ref. to GND)
one or zero
null
VDOUT no load & magnitude at pin
VNOUT no load
4.50 5.00 5.50
-0.25 0 0.25
volts
volts
Operating supply current
V+
V-
SLP1.5 = V+
IDD TX1IN & TX0IN = 0V: no load -
6.0 14.0 mA
IEE TX0IN & TX1IN = 0V: no load -14.0 -6.0
-
mA
ARINC output impedence
HI-8585
HI-8586
ZOUT Note1
-
37.5
-
10
- ohms
- ohms
NOTE :
1. The output resistance is checked by measuring the momentary short circuit current at each ARINC output pin.
HOLT INTEGRATED CIRCUITS
3
Share Link: 