ISL22329WFU10Z View Datasheet(PDF) - Intersil
Part Name
Description
Manufacturer
ISL22329WFU10Z Datasheet PDF : 13 Pages
| |||
ISL22329
Typical Performance Curves (Continued)
1.0
VCC = 2.7V
0.5
50k
0.0
-0.5
VCC = 5.5V
-1.0
-40 -20 0
10k
20 40 60 80
TEMPERATURE (°C)
100 120
FIGURE 7. END-TO-END RTOTAL % CHANGE vs
TEMPERATURE
105
90
10
75
60
45
30
50
15
0
16
36
56
76
96
TAP POSITION (DECIMAL)
FIGURE 8. TC FOR VOLTAGE DIVIDER MODE IN ppm
SCL
SIGNAL AT WIPER
(WIPER UNLOADED)
SIGNAL AT WIPER
(WIPER UNLOADED) MOVEMENT
FROM 7Fh TO 00h
FIGURE 9. MIDSCALE GLITCH, CODE 3Fh TO 40h
Pin Descriptions
Potentiometers Pins
RWI (I = 0,1)
RWi is the wiper terminal and is equivalent to the movable
terminal of a mechanical potentiometer. The position of the
wiper within the array is determined by the WRi register.
SHDN
The SHDN pin forces the resistors to end-to-end open circuit
condition and shorts all RWs to GND. When SHDN is
returned to logic high, the previous latch settings put RWi at
the same resistance setting prior to shutdown. This pin is
logically ANDed with SHDN bit in ACR register. I2C interface
FIGURE 10. LARGE SIGNAL SETTLING TIME
is still available in shutdown mode and all registers are
accessible. This pin must remain HIGH for normal operation.
RW
FIGURE 11. DCP CONNECTION IN SHUTDOWN MODE
8
FN6330.2
September 4, 2009
Share Link: 