LUCL9215GAU View Datasheet(PDF) - Agere -> LSI Corporation

Part Name

Description

Manufacturer

LUCL9215GAU

Short-Loop Sine Wave Ringing SLIC

Agere -> LSI Corporation 

Data Sheet

September 2001

L9215A/G

Short-Loop Sine Wave Ringing SLIC

Supervision (continued)

Power Ring (continued)

PWM Input Signal and Sine Wave Power Ring Sig-

nal Output (continued)

Modulation waveforms showing PWM are in Figure 14

below.

5 V VCC Operation

A PWM signal was generated with an HP™ 8116

Function Generator modulated with a 20 Hz signal. The

optimal frequency used was 10 kHz. THE PWM signal

amplitude was 5.0 V (0 V to 5 V). This signal is shown

in Figure 15.

12-3381(F)

A. Upper = Pwm Signal Centered at 10 kHz

Lower = Modulation Signal

12-3575F

Figure 15. 5 V PWM Signal Amplitude

This input produced 44.96 Vrms ringing signal on

tip/ring under open loop conditions and 42.0 Vrms was

delivered to 5 REN load. The ringing output on ring,

with VCC = 5 V, is shown in Figure 16.

B. Same as A but Expanded

12-3380(F)

Figure 14. Modulation Waveforms

1660

Notes:

The modulating 20 Hz signal THD was measured at 1.3 %.

The tip/ring 20 Hz signal THD was measured at 1 %.

VBAT1 = –70.6 V, VBAT2 = –26.5 V, VCC = 5.019 V.

PWM input 10 kHz, 5.0 Vp-p.

R1 = 10 kΩ, C1 = 0.22 µF, C2 = 0.47 µF.

Figure 16. Ringing Output on RING, with VCC = 5 V

Agere Systems Inc.

31

Share Link: