MAX8614BATD/V View Datasheet(PDF) - Maxim Integrated
Part Name
Description
Manufacturer
MAX8614BATD/V Datasheet PDF : 16 Pages
| |||
MAX8614A/MAX8614B
Dual-Output (+ and -) DC-DC
Converters for CCD
Typical Operating Characteristics (continued)
(TA = +25°C, VCC = VAVCC = 3.6V, SEQ = GND, Figure 1, unless otherwise noted.)
1.2490
REFERENCE VOLTAGE
vs. TEMPERATURE
1.2485
1.2480
1.2475
1.2470
1.2465
1.2460
1.2455
1.2450
-40 -15
10
35
60
85
TEMPERATURE (°C)
1.006
1.005
1.004
1.003
1.002
1.001
1.000
0.999
0.998
0.997
0.996
-40
SWITCHING FREQUENCY
vs. TEMPERATURE
VINV = -7.5V
IOUT = 100mA
VBST = +15V
IOUT = 50mA
-15
10
35
60
85
TEMPERATURE (°C)
Pin Description
PIN
NAME
FUNCTION
1
ONBST
Enable Logic Input. Connect ONBST to AVCC for automatic startup of the step-up converter,
or use ONBST as an independent control of the step-up converter.
2
FBN
Negative Output Feedback Input. Connect a resistor-divider between the negative output and
REF with the center to FBN to set the negative output voltage.
3
AVCC Bias Supply. AVCC powers the IC. AVCC must be connected to VCC.
4
REF 1.25V Reference Voltage Output. Bypass with a 0.22µF ceramic capacitor to GND.
5
GND Ground. Connect GND to PGND with a short trace.
6
FLT
Fault Open-Drain Output. Connect a 100kΩ resistor from FLT to AVCC.
FLT is active low during a fault event and is high impedance in shutdown.
7
FBP
Positive Output-Voltage Feedback Input. Connect a resistor-divider between the positive output and GND
with the center to FBP to set the positive output voltage. FBP is high impedance in shutdown.
8
SEQ
Sequence Logic Input. When SEQ = low, power-on sequence can be independently controlled by ONBST
and ONINV. When SEQ = high, the positive output powers up before the negative output.
9
ONINV
Enable Logic Input. Connect ONINV to AVCC for automatic startup of the inverter,
or use ONINV as an independent control of the inverter.
10
LXP Positive Output Switching Inductor Node. LXP is high impedance in shutdown.
11
PGND Power Ground. Connect PGND to GND with a short trace.
12
PVP
True-Shutdown Load Disconnect Switch. Connect one side of the inductor to PVP and the other side to LXP.
PVP is high impedance in shutdown.
13
VCC
Power Input Supply. VCC supplies power for the step-up and inverting DC-DC converters.
VCC must be connected to AVCC.
14
LXN Negative Output Switching Inductor Node. LXN is high impedance in shutdown.
—
EP
Exposed Pad. Connect exposed pad to ground.
www.maximintegrated.com
Maxim Integrated │ 9
Share Link: 