PCF8566T View Datasheet(PDF) - NXP Semiconductors.
Part Name
Description
Manufacturer
PCF8566T Datasheet PDF : 48 Pages
| |||
NXP Semiconductors
PCF8566
Universal LCD driver for low multiplex rates
Table 24.
Symbol
E
F
G
H
x
y
Tray dimensions …continued
Description
tray width; x direction
tray width; y direction
cut corner to pocket 1,1 center
cut corner to pocket 1,1 center
number of pockets; x direction
number of pockets; y direction
Value
50.8 mm
50.8 mm
5.47 mm
5.47 mm
10
10
18. Soldering of SMD packages
This text provides a very brief insight into a complex technology. A more in-depth account
of soldering ICs can be found in Application Note AN10365 “Surface mount reflow
soldering description”.
18.1 Introduction to soldering
Soldering is one of the most common methods through which packages are attached to
Printed Circuit Boards (PCBs), to form electrical circuits. The soldered joint provides both
the mechanical and the electrical connection. There is no single soldering method that is
ideal for all IC packages. Wave soldering is often preferred when through-hole and
Surface Mount Devices (SMDs) are mixed on one printed wiring board; however, it is not
suitable for fine pitch SMDs. Reflow soldering is ideal for the small pitches and high
densities that come with increased miniaturization.
18.2 Wave and reflow soldering
Wave soldering is a joining technology in which the joints are made by solder coming from
a standing wave of liquid solder. The wave soldering process is suitable for the following:
• Through-hole components
• Leaded or leadless SMDs, which are glued to the surface of the printed circuit board
Not all SMDs can be wave soldered. Packages with solder balls, and some leadless
packages which have solder lands underneath the body, cannot be wave soldered. Also,
leaded SMDs with leads having a pitch smaller than ~0.6 mm cannot be wave soldered,
due to an increased probability of bridging.
The reflow soldering process involves applying solder paste to a board, followed by
component placement and exposure to a temperature profile. Leaded packages,
packages with solder balls, and leadless packages are all reflow solderable.
Key characteristics in both wave and reflow soldering are:
• Board specifications, including the board finish, solder masks and vias
• Package footprints, including solder thieves and orientation
• The moisture sensitivity level of the packages
• Package placement
• Inspection and repair
PCF8566_7
Product data sheet
Rev. 07 — 25 February 2009
© NXP B.V. 2009. All rights reserved.
43 of 48
Share Link: 