DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

Q2426B View Datasheet(PDF) - Unspecified

Part Name
Description
Manufacturer
Q2426B Datasheet PDF : 81 Pages
First Prev 41 42 43 44 45 46 47 48 49 50 Next Last
WM_PRJ_Q2400_PTS_002 - 002
24th January 2003
2.14.1.2 Power OFF
To properly power OFF the module, the application must set the ON/OFF signal
to low and then send the AT+CPOF command to de-register from the network
and switch off the module. Once the « OK » response is issued by the module,
the power supply can be switched off.
POWER SUPPLY
ON/OFF
AT COMMAND
AT+CPOF
OK response
STATE OF THE MODULE
Module
READY
Network dependent
IBB+RF = overall current consumption (Base Band + RF part)
Figure 11 : Power-OFF sequence
Module OFF
IBB+RF<100µA
2.15 BOOT (optional)
This input can be used to download a software in the Flash ROM of the
WISMO Quik Q24x6 Series module. For the applications based on AT
commands this is a backup download procedure only (see chapter Firmware
upgrade). The internal boot procedure is started when this pin is low during
the reset of the module. In normal mode this pin has to be left open. In Internal
boot mode, low level has to be set through a 1Kresistor. If used, this input
has to be driven by an open collector or an open drain.
1KW
BOOT : Pin 12
Switch BOOT
Figure 12 : BOOT pin connection
If Switch Boot = 1, Boot pin 12 = 0, for download mode
If Switch Boot = 0, Boot pin 12 = 1, for normal mode
confidential ©
Page : 41 / 81
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged
without prior written agreement.
Ce document est la propriété exclusive de WAVECOM. Il ne peut être communiqué ou divulgué à
des tiers sans son autorisation préalable.

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]