TDA3607 View Datasheet(PDF) - Philips Electronics
Part Name
Description
Manufacturer
TDA3607 Datasheet PDF : 16 Pages
| |||
Philips Semiconductors
Multiple voltage regulator with switch
Preliminary specification
TDA3607
SYMBOL
PARAMETER
CONDITIONS
MIN.
TYP. MAX. UNIT
Regulator 3 (IREG3 = 5 mA)
VREG3(off)
VREG3
∆VREG3
∆VREGL3
IqREG3
SVRR3
output voltage off
output voltage
line regulation
load regulation
quiescent current
supply voltage ripple
rejection
−
1
1 mA ≤ IREG3 ≤ 400 mA 4.75
5.0
7 V ≤ VP ≤ 18 V
4.75
5.0
7 V ≤ VP ≤ 18 V
−
−
1 mA ≤ IREG3 ≤ 400 mA −
20
IREG3 = 0.4 A
−
10
f = 3 kHz; Vi(p-p) = 2 V
60
70
400
mV
5.25 V
5.25 V
50
mV
50
mV
40
mA
−
dB
VREGd3
drop-out voltage
IREG3 = 400 mA; VP = 9 V; −
note 3
0.45
1.5
V
IREGm3
IREGsc3
αct
current limit
short circuit current
cross talk noise
VREG3 > 4 V; note 4
RL ≤ 0.5 Ω; note 5
note 6
0.45
0.9
−
A
100
300
−
mA
−
25
100
µV
Notes
1. Minimum operating voltage, only if VP has exceeded 4.5 V.
2. The quiescent current is measured in the standby mode. So, the enable inputs of regulator 1, 2 and 3 are LOW
(Ven < 1 V).
3. The drop-out voltage of regulators 1, 2 and 3 is measured between VP and VREGn.
4. At current limit, IREGmn is held constant (see Fig.4 for behaviour of IREGmn).
5. The foldback current protection limits the dissipated power at short-circuit (see Fig.4).
6. Perform the load regulation test with sine wave load of 10 kHz on the regulator output under test. Measure the RMS
ripple voltage on each of the remaining regulator outputs, using a 80 kHz low-pass filter.
1997 May 05
7
Share Link: 