DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

TEA1716T View Datasheet(PDF) - NXP Semiconductors.

Part Name
Description
Manufacturer
TEA1716T
NXP
NXP Semiconductors. 
TEA1716T Datasheet PDF : 35 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
NXP Semiconductors
UBA2071; UBA2071A
Half bridge control IC for CCFL backlighting
When the voltage on the VFB pin exceeds Vth(ov)(VFB), a fault condition is signalled (for
handling of fault conditions, see Section 8.14) and the bias current at the CVFB pin
changed to the discharge current Idch(CVFB). As a result, the switching frequency increases
and the output voltage of the transformer will decrease5. As soon as the voltage at the
VFB pin drops below Vth(ov)(VFB), the CVFB capacitor is charged again and the output
voltage of the transformer will increase again. Because the charging and discharging of
the CVFB capacitor follows the ripple on the VFB pin voltage, the feedback gain of the
voltage control loop is set by the ripple on the feedback signal.
The voltage at the CVFB pin is limited by the oscillator circuit to VCVFB(max) when the
minimum switching frequency fsw(min) is reached, see Figure 10. This ensures an
immediate frequency increase when overvoltage is detected.
fsw(max)
frequency
fsw(min)
0
VCVFB(max)
Voltage on CVFB-pin
014aaa105
Fig 10. Frequency function of CVFB voltage
8.10 Lamp current control
The lamp current control is always active when the IC is on, except if the lamps are off
during PWM dimming. The AC lamp current is sensed by an external resistor connected
to the IFB pin, see Figure 11. The resulting AC voltage on the IFB pin is internally
Double-Sided Rectified (DSR) and compared to a reference level Vref(creg) by an
Operational Transconductance Amplifier (OTA).
When the current is being regulated, switch S1 is closed (conducting). The output current
of the OTA is fed into capacitor C1, which is connected to the CIFB pin. So C1 is charged
and discharged according to the voltage on the IFB pin.
5. Presuming that the load impedance is in inductive region.
UBA2071_A_1
Product data sheet
Rev. 01 — 23 June 2008
© NXP B.V. 2008. All rights reserved.
14 of 35

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]