CXA2074Q/S View Datasheet(PDF) - Sony Semiconductor

Part Name

Description

Manufacturer

CXA2074Q/S

US Audio Multiplexing Decoder

Sony Semiconductor 

CXA2074Q/S

(AUX2-L) (AUX2-R)

(LPIN-L) (LPIN-R)

38 37

42 41

(LPOUT-L) (LPOUT-R)

(AUX1-L)

40 39

36

TVSW

35

PASSSW

(AUX1-R)

VOL-L

VOL-R

(Lch) (Rch)

from MATRIX

BASS

Fig. 4. Sound processor block

TREBLE

(LSOUT-L)

8 (3)

7 (2)

(LSOUT-R)

(1) L + R (MAIN)

After the audio multiplexing signal input from COMPIN (Pin 17 (Pin 14)) passes through MVCA, the

SAP signal and telemetry signal are suppressed by STEREO LPF. Next, the pilot signals are

canceled. Finally, the L – R signal and SAP signal are removed by MAIN LPF, and frequency

characteristics are flattened (de-emphasized) and input to the matrix.

(2) L – R (SUB)

The L – R signal follows the same course as L + R before the pilot signal is canceled. L – R has no

carrier signal, as it is a suppressed-carrier double-sideband amplitude modulated signal (DSB-AM

modulated). For this reason, the pilot signal is used to regenerate the carrier signal (quasi-sine wave)

to be used for the demodulation of the L – R signal. In the last stage, the residual high frequency

components are removed by SUB LPF and the L – R signal is input to the dbx-TV block via the NRSW

circuit after passing through SUBVCA.

(3) SAP

SAP is an FM signal using 5fH as a carrier as shown in the Fig. 1. First, the SAP signal only is

extracted using SAP BPF. Then, this is subjected to FM detection. Finally, residual high frequency

components are removed and frequency characteristics flattened using SAP LPF, and the SAP signal

is input to the dbx-TV block via the NRSW circuit. When there is no SAP signal, the Pin 26 output is

soft muted.

(4) Mode discrimination

Stereo discrimination is performed by detecting the pilot signal amplitude. SAP discrimination is

performed by detecting the 5fH carrier amplitude. NOISE discrimination is performed by detecting the

noise near 25kHz after FM detection of SAP signal.

(5) dbx-TV block

Either the L – R signal or SAP signal input respectively from ST IN (Pin 24 (Pin 22)) or SAP IN (Pin 27

(Pin 25)) is selected by the mode control and input to the dbx-TV block.

The input signal then passes through the fixed de-emphasis circuit and is applied to the variable de-

emphasis circuit. The signal output from the variable de-emphasis circuit passes through an external

capacitor and is applied to VCA (voltage control amplifier). Finally, the VCA output is converted from a

current to a voltage using an operational amplifier and then input to the matrix.

– 23 –

Share Link: