EVAL-AD7687SDZ(RevC) Ver la hoja de datos (PDF) - Analog Devices

Número de pieza

componentes Descripción

Fabricante

EVAL-AD7687SDZ
(Rev.:RevC)

16-Bit, 1.5 LSB INL, 250 kSPS PulSAR Differential ADC in MSOP

Analog Devices 

Data Sheet

ANALOG INPUT

Figure 28 shows an equivalent circuit of the input structure of

the AD7687.

The two diodes, D1 and D2, provide ESD protection for the

analog inputs IN+ and IN−. Care must be taken to ensure that

the analog input signal never exceeds the supply rails by more

than 0.3 V because this causes these diodes to begin to forward-

bias and start conducting current. These diodes can handle a

forward-biased current of 130 mA maximum. For instance,

these conditions could eventually occur when the input buffer’s

(U1) supplies are different from VDD. In such a case, an input

buffer with a short-circuit current limitation can be used to

protect the part.

VDD

IN+

OR IN–

GND

D1

CPIN

D2

RIN

CIN

Figure 28. Equivalent Analog Input Circuit

The analog input structure allows the sampling of the true

differential signal between IN+ and IN−. By using these

differential inputs, signals common to both inputs are rejected,

as shown in Figure 29, which represents the typical CMRR over

frequency.

90

VDD = 5V

80

VDD = 2.5V

70

60

50

40

1

10

100

FREQUENCY (kHz)

Figure 29. Analog Input CMRR vs. Frequency

1000

AD7687

During the acquisition phase, the impedance of the analog

inputs (IN+ or IN−) can be modeled as a parallel combination

of capacitor, CPIN, and the network formed by the series

connection of RIN and CIN. CPIN is primarily the pin capacitance.

RIN is typically 3 kΩ and is a lumped component made up of

some serial resistors and the on resistance of the switches. CIN is

typically 30 pF and is mainly the ADC sampling capacitor.

During the conversion phase, where the switches are opened,

the input impedance is limited to CPIN. RIN and CIN make a

1-pole, low-pass filter that reduces undesirable aliasing effects

and limits the noise.

When the source impedance of the driving circuit is low, the

AD7687 can be driven directly. Large source impedances

significantly affect the ac performance, especially total

harmonic distortion (THD). The dc performances are less

sensitive to the input impedance. The maximum source

impedance depends on the amount of THD that can be

tolerated. The THD degrades as a function of the source

impedance and the maximum input frequency, as shown in

Figure 30.

–60

–70

–80

–90

RS = 250Ω

–100

RS = 100Ω

–110

RS = 50Ω

–120 RS = 33Ω

0

25

50

75

100

FREQUENCY (kHz)

Figure 30. THD vs. Analog Input Frequency and Source Resistance

Rev. C | Page 15 of 28

Share Link: