G6A(2009) Ver la hoja de datos (PDF) - OMRON Corporation

Número de pieza

componentes Descripción

Fabricante

G6A
(Rev.:2009)

Low Signal Relay

OMRON Corporation 

■ Characteristics

Type

Non-latching

Latching

Contact resistance (See note 1)

50 mΩ max.

Operate (set) time

(See note 2)

DPDT

4PDT

5 ms max. (mean value approx. 3 ms)

7 ms max. (mean value approx 3.80 ms)

5 ms max. (mean value approx. 2.50 ms)

7 ms max. (mean value approx. 3.30 ms)

Release (reset) time

(See note 2)

DPDT

4PDT

3 ms max. (mean value approx. 1.20 ms) 5 ms max. (mean value approx. 2.50 ms)

5 ms max. (mean value approx. 1.30 ms) 7 ms max. (mean value approx. 2.70 ms)

Min. set/reset signal width DPDT

7 ms min.

4PDT

15 ms min.

Operating frequency

Mechanical

36,000 operations/hour

Electrical

1,800 operations/hour (under rated load)

Insulation resistance (See note 3)

1,000 MΩ min. (at 500 VDC); except for set-reset

Dielectric strength

1,000 VAC, 50/60 Hz for 1 minute between coil and contacts

1,000 VAC, 50/60 Hz for 1 minute between contacts of different poles

1,000 VAC, 50/60 Hz for 1 minute between contacts of same pole

250 VAC, 50/60 Hz for 1 minute between set and reset coils

Surge withstand voltage

1,500 V (10 x 160 μs) (conforms to FCC Part 68)

Vibration

Mechanical durability 10 to 55 Hz; 5 mm double amplitude

Malfunction durability 10 to 55 Hz; 3.3 mm double amplitude

Shock

Mechanical durability 1,000 m/s2 (Approx. 100G

Malfunction durability DPDT: 500 m/s2 (Approx. 50 G); 4PDT: 300 m/s2 (Approx. 30 G)

Ambient temperature

-40° to 70°C with no icing

Humidity

5% to 85% RH

Service life

Mechanical

100 million operations min. (at 36,000 operations/hour)

Electrical

500,000 operations min. (at 1,800 operations/hr) See “Characteristic Data”

Weight

DPDT

Approx. 3.5 g

4PDT

Approx. 6.0 g

Note: 1. The contact resistance was measured with 10 mA at 1 VDC with a fall-of-potential method.

2. Values in parentheses are typical values unless otherwise stated.

3. The insulation resistance was measured with a 500-VDC megohmmeter applied to the same parts as those for checking the dielectric strength

(except between the set and reset coil).

4. The above values are initial values.

■ Approvals

UL Recognized (File No. E41515) / CSA Certified (File No. LR31928) - - Ambient Temp. = 40°C

Type

G6A( )-274P-ST( )-US

Contact form

DPDT

Coil rating

1.5 to 48 VDC

Contact ratings

1 A at 125 VAC (General Purpose)

2 A at 30 VDC (General Purpose)

0.6 A at 110 VDC (General Purpose)

Number of test operations

6,000

Note: 1. The rated values approved by each of the safety standards (e.g., UL and CSA) may be different from the performance characteristics

individually defined in this catalog.

2. In the general interest of product improvement, specifications are subject to change.

Low Signal Relay G6A

85

Share Link: