AD9786BSV Ver la hoja de datos (PDF) - Analog Devices

Número de pieza

componentes Descripción

Fabricante

AD9786BSV

16-Bit, 200 MSPS/500 MSPS TxDAC+® with 2×/4×/8× Interpolation and Signal Processing

Analog Devices 

AD9786

TERMINOLOGY

Linearity Error (Integral Nonlinearity or INL)

Linearity error is defined as the maximum deviation of the

actual analog output from the ideal output, determined by a

straight line drawn from zero to full scale.

Differential Nonlinearity (DNL)

DNL is the measure of the variation in analog value, normal-

ized to full scale, associated with a 1 LSB change in digital

input code.

Monotonicity

A D/A converter is monotonic if the output either increases or

remains constant as the digital input increases.

Offset Error

The deviation of the output current from the ideal of zero is

called offset error. For IOUTA, 0 mA output is expected when the

inputs are all 0s. For IOUTB, 0 mA output is expected when all

inputs are set to 1.

Gain Error

The difference between the actual and ideal output span. The

actual span is determined by the output when all inputs are set

to 1, minus the output when all inputs are set to 0.

Output Compliance Range

The range of allowable voltage at the output of a current-output

DAC. Operation beyond the maximum compliance limits can

cause either output stage saturation or breakdown, resulting in

nonlinear performance.

Temperature Drift

Temperature drift is specified as the maximum change from the

ambient (+25°C) value to the value at either TMIN or TMAX. For

offset and gain drift, the drift is reported in ppm of full-scale

range (FSR) per degree Celsius. For reference drift, the drift is

reported in ppm per degree Celsius.

Power Supply Rejection

The maximum change in the full-scale output as the supplies

are varied from minimum to maximum specified voltages.

Settling Time

The time required for the output to reach and remain within a

specified error band about its final value, measured from the

start of the output transition.

Glitch Impulse

Asymmetrical switching times in a DAC give rise to undesired

output transients that are quantified by a glitch impulse. It is

specified as the net area of the glitch in pV-sec.

Spurious-Free Dynamic Range (SFDR)

The difference between the rms amplitude of the output signal

and the amplitude of the peak spurious signal over the specified

bandwidth. The units are often in dBc (dB with respect to the

carrier).

Total Harmonic Distortion (THD)

THD is the ratio of the rms sum of the first six harmonic

components to the rms value of the measured fundamental. It is

expressed as a percentage or in decibels.

Signal-to-Noise Ratio (SNR)

SNR is the ratio of the rms value of the measured output signal

to the rms sum of all other spectral components below the

Nyquist frequency, excluding the first six harmonics and dc.

The value for SNR is expressed in decibels.

Interpolation Filter

If the digital inputs to the DAC are sampled at a multiple rate of

fDATA (interpolation rate), a digital filter can be constructed that has

a sharp transition band near fDATA/2. Images that would typically

appear around fDAC (output data rate) can be greatly suppressed.

Pass Band

Frequency band in which any input applied therein passes

unattenuated to the DAC output.

Stop-Band Rejection

The amount of attenuation of a frequency outside the pass band

applied to the DAC, relative to a full-scale signal applied at the

DAC input within the pass band.

Rev. B | Page 12 of 56

Share Link: