FL05-0001-G Ver la hoja de datos (PDF) - M/A-COM Technology Solutions, Inc.

Número de pieza

componentes Descripción

Fabricante

FL05-0001-G

Low Cost SMT High Pass Filter 800 – 3000 MHz

M/A-COM Technology Solutions, Inc. 

FL05-0001-G

Low Cost SMT High Pass Filter

800 – 3000 MHz

Rev. V2

Electrical Specifications: TA = 25°C, Z0 = 50Ω

Parameter

Insertion Loss: 800 – 850 MHz

850 – 3000 MHz

VSWR: 800 – 3000 MHz

Rejection: DC-400 MHz

Units

dB

dB

—

dB

Min

—

—

—

15

Typ

—

0.5

1.5:1

20

Max

1.2

1.0

1.8:1

—

Absolute Maximum Ratings 1,2

Parameter

Input Power

Operating Temperature

Storage Temperature

Absolute Maximum

2 W CW

-40°C to +85°C

-65°C to +150°C

1. Exceeding any one or combination of these limits may cause

permanent damage to this device.

2. M/A-COM does not recommend sustained operation near

these survivability limits.

Handling Procedures

Please observe the following precautions to avoid

damage:

Static Sensitivity

GMIC Circuits are sensitive to electrostatic

discharge (ESD) and can be damaged by static

electricity. Proper ESD control techniques should

be used when handling these devices.

Typical Performance Curves @ 25ºC

Insertion Loss vs. Frequency

0

-5

-10

-15

-20

-25

-30

-35

0

500

1000

1500

2000

2500

3000

Frequency (MHz)

VSWR vs. Frequency

2 .0

1.8

Output

Input

1.6

1.4

1.2

1.0

0

50 0

10 0 0

1500

2000

2 50 0

3000

Frequency (MHz)

2

ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400

is considering for development. Performance is based on target specifications, simulated results,

and/or prototype measurements. Commitment to develop is not guaranteed.

PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology

• India Tel: +91.80.4155721

• China Tel: +86.21.2407.1588

Visit www.macomtech.com for additional data sheets and product information.

Solutions has under development. Performance is based on engineering tests. Specifications are

typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make

Commitment to produce in volume is not guaranteed.

changes to the product(s) or information contained herein without notice.

Share Link: