MC100EP139MNTXG(2016) Ver la hoja de datos (PDF) - ON Semiconductor
Número de pieza
componentes Descripción
Fabricante
MC100EP139MNTXG Datasheet PDF : 14 Pages
| |||
MC10EP139, MC100EP139
Table 11. AC CHARACTERISTICS (VCC = 0 V; VEE = −3.0 V to −5.5 V or VCC = 3.0 V to 5.5 V; VEE = 0 V (Note 1))
−40°C
25°C
85°C
Symbol
Characteristic
Min Typ Max Min Typ Max Min Typ Max Unit
fmax
Maximum Frequency
>1
>1
>1
GHz
(See Figures 6, 7, 8 and 9 Fmax
/JITTER)
tPLH,
tPHL
Propagation Delay
CLK, Q (Diff)
MR, Q
ps
550 700 800 600 750 900 675 825 975
700 800 900 700 850 1000 800 950 1100
tRR
Reset Recovery
ts
Setup Time
EN, CLK
DIVSEL, CLK
200 100
200 100
200 100
ps
ps
200 120
200 120
200 120
400 180
400 180
400 180
th
Hold Time
CLK, EN
CLK, DIVSEL
ps
100 50
100 50
100 50
200 140
200 140
200 140
tPW
Minimum Pulse Width
MR
ps
550 450
550 450
550 450
tSKEW
Within Device Skew
Q, Q
Device-to-Device Skew (Note 2)
50 100
200 300
50 100
200 300
50 100 ps
200 300
tJITTER
Random Clock Jitter (RMS)
(See Figures 6, 7, 8 and 9 Fmax/JIT-
TER)
0.2 < 1.0
0.2 < 1.0
0.2 < 1.5 ps
VPP
Input Voltage Swing (Differential Con-
150 800 1200 150 800 1200 150 800 1200 mV
figuration)
tr
Output Rise/Fall Times
tf
Q, Q (20%−80%)
ps
110 180 250 125 190 275 150 215 300
NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit
board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared
operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification limit
values are applied individually under normal operating conditions and not valid simultaneously.
1. Measured using a 750 mV source, 50% duty cycle clock source. All loading with 50 W to VCC − 2.0 V (see Figure 10).
2. Skew is measured between outputs under identical transitions. Duty cycle skew is defined only for differential operation when the delays
are measured from the cross point of the inputs to the cross point of the outputs.
Product parametric performance is indicated in the Electrical Characteristics for the listed test conditions, unless otherwise noted. Product
performance may not be indicated by the Electrical Characteristics if operated under different conditions.
www.onsemi.com
8
Share Link: 