Slotted Optical Switch
OPB827, OPB828, OPB829Z Series
Absolute Maximum Ratings (TA=25°C unless otherwise noted)
Storage and Operating Temperature
OPB827, OPB828
OPB829Z
Lead Soldering Temperature (1/16 inch [1.6 mm] from case for 5 seconds with soldering iron) (1)
-40° C to +85° C
-40° C to +80° C
260° C
Input Diode
Forward DC Current
Peak Forward Current (1µs pulse width, 300 pps)
Reverse DC Voltage
Power Dissipation (2)
50 mA
3A
2V
100 mW
Output Phototransistor
Collector-Emitter Voltage
Emitter-Collector Voltage
Collector DC Current
Power Dissipation (2)
30 V
5V
30 mA
100 mW
Notes:
(1) RMA flux is recommended. Duration can be extended to 10 seconds maximum when flow soldering.
(2) Derate linearly 1.82 mW/° C above 25° C.
(3) Methanol or isopropanol are recommended as cleaning agents. Plastic housing is soluble in chlorinated hydrocarbons and ketones.
(4) All parameters were tested using pulse technique.
Electrical Characteristics (TA = 25°C unless otherwise noted)
SYMBOL
PARAMETER
MIN TYP MAX UNITS
TEST CONDITIONS
Input Diode (See OP240 for additional information—for reference only)
VF
Forward Voltage
-
- 1.7
V
IR
Reverse Current
-
- 100 µA
Output Transistor (See OP550 for additional information—for reference only)
IF = 20 mA
VR = 2 V
V(BR)CEO Collector-Emitter Breakdown Voltage 30
V(BR)ECO Emitter-Collector Breakdown Voltage 5
ICEO
Collector-Emitter Dark Current
-
Coupled
-
-
V IC = 1 mA
-
-
V IE = 100 µA
-
100
nA VCE = 10 V, IF = 0, EE = 0
VCE(SAT) Saturation Voltage
-
-
0.6
V IC = 1800 µA, IF = 20 mA
IC(ON)
On-State Collector Current
1800 -
-
µA VCE = 0.6 V, IF = 20 mA
OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.
OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006
Phone: (972) 323-2200 or (800) 341-4747
FAX: (972) 323-2396 sensors@optekinc.com www.optekinc.com
Issue A.2 09/06
Page 3 of 5