AD831AP-EB PDF VIEW DOWNLOAD , AD831AP-EB Hoja de datos -Analog Devices DatsheetQ ...

AD831AP-EB Ver la hoja de datos (PDF) - Analog Devices

Número de pieza

componentes Descripción

Fabricante

AD831AP-EB

Low Distortion Mixer

Analog Devices

AD831AP-EB Datasheet PDF : 16 Pages

1 2 3 4 5 6 7 8 9 10 Next Last

THEORY OF OPERATION

The AD831 consists of a mixer core, a limiting amplifier, a low

noise output amplifier, and a bias circuit (Figure 1).

The mixer’s RF input is converted into differential currents by

a highly linear, Class A voltage-to-current converter, formed by

transistors Q1, Q2 and resistors R1, R2. The resulting currents

drive the differential pairs Q3, Q4 and Q5, Q6. The LO input is

through a high gain, low noise limiting amplifier that converts the

–10 dBm LO input into a square wave. This square wave drives

the differential pairs Q3, Q4 and Q5, Q6 and produces a high

level output at IFP and IFN—consisting of the sum and differ-

ence frequencies of the RF and LO inputs—and a series of lower

level outputs caused by odd harmonics of the LO frequency mix-

ing with the RF input.

An on-chip network supplies the bias current to the RF and LO

inputs when these are ac-coupled; this network is disabled when

the AD831 is dc-coupled.

AD831

When the integral output amplifier is used, pins IFN and IFP

are connected directly to pins AFN and AFP; the on-chip load

resistors convert the output current into a voltage that drives

the output amplifier. The ratio of these load resistors to resistors

R1, R2 provides nominal unity gain (0 dB) from RF-to-IF. The

expression for the gain, in decibels, is

GdB

= 20

log10

ËÁ

¯˜

ËÁ

¯˜

ËÁ

¯˜

(1)

where:

4 is the amplitude of the fundamental component of a

p squarewave.

1 is the conversion loss.

p is the small signal dc gain of the AD831 when the LO input

2 is driven fully positive or negative.

��

�

��

� ��

��

Figure 1. Simplified Schematic Diagram

��

REV. C

–7–

Share Link: