MP62160DD Ver la hoja de datos (PDF) - Monolithic Power Systems

Número de pieza

componentes Descripción

Fabricante

MP62160DD

3.3V/5V, Single-Channel 2A Current-Limited Power Distribution Switch with Output Discharge

Monolithic Power Systems 

MP62160/MP62161 –CURRENT-LIMITED POWER DISTRIBUTION SWITCH

FUNCTION BLOCK DIAGRAM

IN

EN*

UVLO

Charge

Pump

Logic

Current

Sense

--

AMP

+

Deglitch

+

Vref

--

OUT

FLAG

Thermal

Sense

GND

*: EN is active high for MP62161

Figure2—Functional Block Diagram

DETAILED DESCRIPTION

Over Current

When the load exceeds trip current (minimum

threshold current triggering constant-current

mode) or a short is present, MP62160/MP62161

switches into to a constant-current mode (current

limit value). MP62160/MP62161 will be shutdown

only if the over current condition stays long

enough to trigger thermal protection.

Trigger over current protection for different

overload conditions occurring in applications:

1) The output has been shorted or overloaded

before the device is enabled or input applied.

MP62160/MP62161 detects the short or

overload and immediately switches into a

constant-current mode.

2) A short or an overload occurs after the device

is enabled. After the current-limit circuit has

been tripped (reached the trip current

threshold), the device switches into constant-

current mode. However, high current may

flow for a short period of time before the

current-limit circuit can react.

3) Output current has been gradually increased

beyond the recommended operating current.

The load current rises until the trip current

threshold is reached or until the thermal limit

of the device is exceeded. The

MP62160/MP62161 is capable of delivering

current up to the trip current threshold without

damaging the device. Once the trip threshold

has been reached, the device switches into

its constant-current mode.

Flag Response

The FLAG pin is an open drain configuration.

This FLAG will report a fail mode after an 8ms

deglitch timeout. This is used to ensure that no

false fault signals are reported. This internal

deglitch circuit eliminates the need for extend

components. The FLAG pin is not deglitched

during an over temp. or a voltage lockout.

MP62160_MP62161 Rev. 0.9

www.MonolithicPower.com

7

7/8/2010

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2010 MPS. All Rights Reserved.

Share Link: