AT42QT1110-AZ Ver la hoja de datos (PDF) - Atmel Corporation
Número de pieza
componentes Descripción
Fabricante
AT42QT1110-AZ Datasheet PDF : 50 Pages
| |||
5.4 Reset (0x04)
The Reset command forces the QT1110 to reset. If the setups data is present in the EEPROM, the setups are
loaded into the device. Otherwise default settings are applied.
The host must wait for at least 160 ms for the operation to be completed before communications can be
re-established.
5.5 Sleep (0x05)
The Sleep command puts the device into sleep mode (see Section 4.3 on page 18).
The host must wait for at least 150 µs after a low signal is applied to the SS or CHANGE pin to wake the device
before communications can be re-established.
5.6 Store to EEPROM (0x0A)
Stores the current RAM contents to the QT1110 internal EEPROM. When the device is reset, it will automatically
reload these settings.
The host must wait for at least 200 ms for the operation to be completed before communications can be
re-established.
5.7 Restore from EEPROM (0x0B)
Settings stored in EEPROM are automatically loaded into RAM when the device is reset. If desired, these settings
can be re-loaded into RAM using the Restore from EEPROM command.
The host must wait for at least 150 ms for the operation to be completed before communications can be
re-established.
5.8 Erase EEPROM (0x0C)
This command erases the settings stored in EEPROM and then resets the QT1110. This causes the QT1110 to
revert to its default settings.
The host must wait for at least 50 ms for the operation to be completed before communications can be
re-established.
5.9 Recover EEPROM (0x0D)
This command “undeletes†the setup data that was previously stored in the device EEPROM and has been erased
using the “Erase EEPROM†command.
Note: If valid settings have not previously been stored in the device EEPROM, the QT1110 continues to operate
under the default settings.
The host must wait for at least 50 ms for the operation to be completed before communications can be
re-established.
AT42QT1110-MZ / AT42QT1110-AZ [DATASHEET]
23
9570J–AT42–05/2013
Share Link: 