LTC1531CSW データシートの表示（PDF） - Linear Technology

部品番号

コンポーネント説明

メーカー

LTC1531CSW

Self-Powered Isolated Comparator

Linear Technology 

LTC1531

TYPICAL PERFORMANCE CHARACTERISTICS

30

TA = 25°C

25

20

VCC = 4.5V

15

10

VCC = 5.5V

VCC = 5V

5

0

0

1

2

3

4

IVREG (mA)

1531 F03

Figure 3. Average tSAMPLE vs IVREG

4500V

BREAKDOWN

LIMIT

2500VRMS

450V

SLEW RATE = (π)(f)(VP-P)

= (1.11)(f)(VRMS)

50V/µs

(1.11)(f)

=

VRMS

45V

4.5V

450mV

10k

100k

1M

10M 100M

FREQUENCY (Hz)

1531 F04

Figure 4. VRMS vs Frequency

PIN FUNCTIONS

VCC (Pin 1): Powered Side Power Supply.

SHDN (Pin 2): Active Low Chip Shutdown. A low signal

causes the circuitry to power down. DATA logic output

level will be reset to zero during power-down.

ZCNEG (Pin 3): Zero-Cross Comparator Negative Input.

ZCPOS (Pin 4): Zero-Cross Comparator Positive Input.

VPW (Pin 11): Isolated Power Supply. Connect to an

external storage capacitor.

CMPOUT (Pin 12): Isolated Latched Comparator Data.

CMPOUT is active when VREG is on. The CMPOUT output

can be used on the isolated side for hysteresis (see

applications). The output will contain the result of the

previous comparison. When VREG is low, the CMPOUT pin

is Hi-Z.

VREG (Pin 13): Isolated 2.5V Regulated Output. Pulsed on

for 100µs with a maximum load current of 5mA. VREG also

supplies power to the CMPOUT output (Pin 12).

ISOGND (Pin 14): Isolated Side Power Ground.

V4 (Pin 15): Comparator Negative Input. The comparator

inputs are summed together with the comparison output

equal to (V1 + V2)/2 > (V3 + V4)/2 or equivalently (V1 – V3)

> (V4 – V2).

V3 (Pin 16): Comparator Negative Input.

V2 (Pin 17): Comparator Positive Input.

V1 (Pin 18): Comparator Positive Input.

VALID (Pin 25): Pulsed Output. Indicates when valid data

was received from the comparator. May be used to clock

DATA to external circuitry.

DATA (Pin 26): Latched Comparator Result. DATA holds

the value of the last valid comparison result. DATA changes

only when a valid comparison was received from the

isolated side.

ZCDATA (Pin 27): A 24µs to 30µs Pulsed Output. The

pulse occurs when the DATA output is high and the zero-

cross comparator inputs (ZCPLS-ZCNEG) cross zero volts

differential. Typically the zero-cross input signal is an RC

phase shifted AC sine wave. This output is a TTL level pulse

that can be used for firing an external triac.

GND (Pin 28): Power Supply Low Impedance Ground

Connection.

4

Share Link: