HIP4083 データシートの表示（PDF） - Intersil

部品番号

コンポーネント説明

メーカー

HIP4083

80V, 300mA Three Phase High Side Driver

Intersil 

HIP4083

Typical Application: High Side Switch

REFRESH

BOOT STRAP CAPACITOR

AND DIODE REQUIRED 80V

12V

MICRO-

PROCESSOR

DIS

AHI

BHI

CHI

HIP4083

AHO

BHO

CHO

GND

LIGHT

Pin Descriptions

PIN

NUMBER

6

11

16

SYMBOL

AHB

BHB

CHB

(xHB)

1

AHI

2

BHI

3

CHI

(xHI)

5

VSS

13

UVLO

4

DIS

7

AHO

10

BHO

15

CHO

(xHO)

8

AHS

9

BHS

14

CHS

(xHS)

12

VDD

DESCRIPTION

Gate driver supplies. One external bootstrap diode and one capacitor are required for each. The bootstrap diode

and capacitor may be omitted when the HIP4083 is used to drive the lower gates in three phase full bridge

applications. In this case, tie all three xHB pins to VDD and tie the xHS pins to the sources of the lower FETs. In

full bridge applications, the lower FETs must be turned on first at start up to refresh the bootstrap capacitors. In

high side switch applications, the load will keep xHS low and refresh should happen automatically at start up.

Logic level inputs. Logic at these three pins controls the three output drivers, AHO, BHO and CHO. When xHI is

low, xHO is high. When xHI is high, xHO is low. DIS (Disable) overrides all input signals. xHI can be driven by

signal levels of 0V to 15V (no greater than VDD).

Chip ground.

Undervoltage setting. A resistor can be connected between this pin and VSS to program the under voltage set

point - see Figure 7. With this pin not connected the undervoltage set point is typically 7V. When this pin is tied to

VDD, the undervoltage set point is typically 6.2V.

Disable input. Logic level input that when taken high sets all three outputs low. DIS high overrides all other inputs.

When DIS is taken low the outputs are controlled by the other inputs. DIS can be driven by signal levels of 0V to

15V (no greater than VDD).

Gate connections. Connect to the gates of the power MOSFETs in each phase.

MOSFET source connection. Connect the sources of the power MOSFETs and the negative side of the bootstrap

capacitors to these pins. In high side switch applications, 2mA of current will flow out of these pins into the load

when the upper FETs are off. This current is necessary to guarantee that the upper FETs stay off. This current

tends to pull xHS high. For proper refresh, the load must pull the voltage on xHS down to at least 7V below VDD.

For example, when VDD = 12V, xHS must be pulled down to 5V. Therefore, the minimum load necessary for

proper refresh is given by the following equation: RMIN = 5V/2mA = 2.5kΩ. So in this case, if the load has an

impedance less than 5kΩ, refresh will happen automatically at start up.

Positive supply rail. Bypass this pin to VSS with a capacitor >1µF. In applications where the bus voltage and chip

VDD are at the same potential, it is a good idea to run a separate line from the supply to each. This greatly

simplifies the filtering requirements.

4

Share Link: