STM806RM6E(2004) データシートの表示（PDF） - STMicroelectronics

部品番号

コンポーネント説明

メーカー

STM806RM6E
(Rev.:2004)

3V Supervisor with Battery Switchover

STMicroelectronics 

STM690/704/795/802/804/805/806

Using a SuperCap™ as a Backup Power

Source

SuperCaps™ are capacitors with extremely high

capacitance values (e.g., order of 0.47F) for their

size. Figure 15 shows how to use a SuperCap as

a back-up power source. The SuperCap may be

connected through a diode to the VCC supply.

Since VBAT can exceed VCC while VCC is above

the reset threshold, there are no special precau-

tions when using these supervisors with a Super-

Cap.

Figure 15. Using a SuperCap™

5V

VCC

VOUT

To external SRAM

STMXXX

VBAT

RST

GND

To µP

Negative-Going VCC Transients

The STM690/704/795/802/804/805/806 Supervi-

sors are relatively immune to negative-going VCC

transients (glitches). Figure 32., page 20 was gen-

erated using a negative pulse applied to VCC,

starting at VRST + 0.3V and ending below the reset

threshold by the magnitude indicated (comparator

overdrive). The graph indicates the maximum

pulse width a negative VCC transient can have

without causing a reset pulse. As the magnitude of

the transient increases (further below the thresh-

old), the maximum allowable pulse width decreas-

es. Any combination of duration and overdrive

which lies under the curve will NOT generate a re-

set signal. Typically, a VCC transient that goes

100mV below the reset threshold and lasts 40µs or

less will not cause a reset pulse. A 0.1µF bypass

capacitor mounted as close as possible to the VCC

pin provides additional transient immunity.

AI08805

12/31

Share Link: