PS396/PS397
Precision, 16-Channel/Dual 8-Channel,
17V Analog Multiplexers 1122334455667788990011223344556677889900112233445566778899001122112233445566778899001122334455667788990011223344556677889900112211223344556677889900112233445566778899001122334455667788990011221122334455667788990011223344556677889900112233445566778899001122112233445566778899001122
Electrical Characteristics Single +3.3V Supply
(V+ = 3.0V to 3.6V, GND = 0V, VINH = 2.4V, VINL = 0.8V, TA = TMin to TMax, unless otherwise noted.)
Parameter
Symbol
Conditions
Min.(2) Typ.(2) Max.(2) Units
Switch
Analog Signal Range
On-Resistance
Dynamic
Transition Time(3)
Enable Turn-On-
Time(3)
Enable Turn-Off-
Time(3)
Charge Injection (3)
VANALOG (note 3)
RO N
INO = 1mA, VCOM = 1.5V,
V+ = 3V
tTRAN S
tO N (EN )
tO FF(EN )
VCTE
VIN = 2.4V, VNO1 = 1.5V,
VNO8 = 0V, Figure 2
VINH = 2.4V, VINL = 0V,
VNO1 = 1.5V, Figure 3
VINH = 2.4V, VINL = 0V,
VNO1 = 1.5V, Figure 3
CL = 1.0nF, VGEN = 0V,
RGEN = 0 Ohm Figure 6
TA = +25°C
TA = TMIN to TMAX
TA = +25°C
TA = TMIN to TMAX
TA = +25°C
TA = +25°C
TA = +25°C
V
V+
V
315 550
Ohm
650
230
575
750
260
500
ns
135
400
1
5
pC
Notes:
2. The algebraic covention, where the most negative value is a minimum and the most positive value a maximum, is used in this data sheet.
3. Guaranteed by design
4. ∆RON = ∆RON(MAX) RON(MIN)
5. Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the specified analog
signal ranges. i.e., VNO = 3V to 0V and 0V to 3V.
6. Leakage parameters are 100% tested at maximum rated hot temperature and guaranteed by correlation at +25°C.
6. See Figure 6. Off isolation = 20log10 VCOM/VNC or VNO, VCOM = output, VNC or NO = input to off switch
7. Worst-case isolation is on channel 4 because of its proximity to the COM pin. Off-isolation - 20log VCOM/VNO,
VCOM = output, VNO = input to off switch.
8. Leakage testing at single supply is guaranteed by correlation testing with dual supplies.
8
PS8443A
06/12/00