LT1683IG 데이터 시트보기 (PDF) - Linear Technology
부품명
상세내역
제조사
LT1683IG Datasheet PDF : 26 Pages
| |||
LT1683
APPLICATIONS INFORMATION
Gate Driver Considerations
In general, the MOSFETs should be positioned as close to
the part as possible to minimize inductance.
When the part is active the gate drives will be pulled low
to less than 0.2V. When the part is off, the gate drives
contain a 40k resistor in series with a diode to ground
that will offer passive holdoff protection. If you are using
some logic-level MOSFETs this might not be sufficient. A
resistor may be placed from gate to ground, however the
value should be reasonably high to minimize DC losses
and possible AC issues.
The gate drive source current comes from VIN. The sink
current exits through PGND. In general the decoupling
cap should be placed close to these two pins.
Switching Diodes
In general, switching diodes should be Schottky diodes.
Size and breakdown voltage depend on the specific
converter. A lower forward drop will improve converter
efficiency. No other special requirements are needed.
PCB Layout Considerations
As with any switcher careful consideration should be
given to PC board layout. Because this part reduces high
frequency EMI the board layout is less critical, however
high currents and voltages still produce the need for careful
board layout to eliminate poor and erratic performance.
Basic Considerations
Keep the high current loops physically small in area. The
main loops are shown in Figure 8: the power switch loops
(A and B) and the rectifier loop (C and D). These loops can
be kept small by physically keeping the components close
to one another. In addition, connection traces should be
kept wide to lower resistance and inductances. Components
should be placed to minimize connecting paths. Careful
attention to ground connections must also be maintained.
Without getting into elaborate detail be careful that currents
from different high current loops do not get coupled into
the ground paths of other loops. Using singular points
of connection for the grounds is the best way to do this.
The two major points of connection are the bottom of the
input decoupling cap and the bottom of the output decou-
pling cap. Typically the sense resistor device PGND and
device GND will tie to the bottom of the input cap.
There are two other loops to pay attention to. The current
slew involves a high bandwidth control that goes through
the MOSFET switch, the sense resistor and into the CS
pin of the part and out the GATE pin to the MOSFET. Trace
inductance and resistance should be kept low on the GATE
drive trace. The CS trace should have low inductance. The
sense resistor should be physically close to PGND and the
MOSFETs’ sources.
Finally care should be taken with the CAP A, CAP B pins.
The part will tolerate stray capacitance to ground on these
pins (<5pF) however stray capacitance to the respective
drains should be minimized. This path would provide an
alternate capacitive path for the voltage slew.
More Help
AN70 contains information about low noise switchers and
measurement of noise and should be consulted. AN19 and
AN29 also have general knowledge concerning switching
regulators. Also, our Application Department is always
ready to lend a helping hand.
A
CIN
B
1
3D
2
4C
GATE A
CS
GATE B
A
COUT
Figure 8
1683 F08
1683fd
22
Share Link: 