Crane Aerospace & Electronics Power Solutions
MHF+ Single, Dual and Triple DC/DC Converter Cases
28 VOLT INPUT – 15 WATT
BOTTOM VIEW CASE E2
Seam Seal
Projection Weld
1.130 max. (28.70)
0.960 (24.38)
0.030 dia.
(0.76)
Squared corner and dot on top
of case indicate pin one.
1
2345
9
0.160 (4.06)
0.000
876
Seal Hole: 0.080 ±0.002 (2.03 ±0.05)
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device.
Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin
Materials
Header Cold Rolled Steel/Nickel/Gold
Cover Kovar/Nickel
Pins
#52 alloy/Gold compression glass seal
Case E2, Rev C, 20060111
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications without notice.
Copyright © 1999-2006 Interpoint Corp. All rights reserved.
FIGURE 33: CASE E2 — TRIPLE MODELS
www.craneae.com
Page 16 of 20
Rev K - 20060613