AD871SE/883B 데이터 시트보기 (PDF) - Unspecified

부품명

상세내역

제조사

AD871SE/883B

MICROCIRCUIT, LINEAR, A/D CONVERTER, 12-BIT, 5 MSPS, MONOLITHIC SILICON

Unspecified 

TABLE II. Electrical test requirements.

Test requirements

Interim electrical

parameters (see 4.2)

Final electrical

parameters (see 4.2)

Group A test

requirements (see 4.4)

Group C end-point electrical

parameters (see 4.4)

Group D end-point electrical

parameters (see 4.4)

Group E end-point electrical

parameters (see 4.4)

Subgroups

(in accordance with

MIL-STD-883,

method 5005, table I)

Device

class M

1

Subgroups

(in accordance with

MIL-PRF-38535, table III)

Device

class Q

1

Device

class V

1

1,2,3,9,10,11 1/

1,2,3,9,10,11

1

1

----

1,2,3,9, 1/

10,11

1,2,3,9,

10,11

1

1

----

1,2,3,9, 1/

10,11

1,2,3,9,

10,11

1,2,3,9,

10,11

1,2,3,9,

10,11

----

1/ PDA applies to subgroup 1.

4.4.3 Group D inspection. The group D inspection end-point electrical parameters shall be as specified in table II herein.

4.4.4 Group E inspection. Group E inspection is required only for parts intended to be marked as radiation hardness

assured (see 3.5 herein).

a. End-point electrical parameters shall be as specified in table II herein.

b. For device classes Q and V, the devices or test vehicle shall be subjected to radiation hardness assured tests as

specified in MIL-PRF-38535 for the RHA level being tested. For device class M, the devices shall be subjected to

radiation hardness assured tests as specified in MIL-PRF-38535, appendix A for the RHA level being tested. All

device classes must meet the postirradiation end-point electrical parameter limits as defined in table I at

TA = +25°C ±5°C, after exposure, to the subgroups specified in table II herein.

c. When specified in the purchase order or contract, a copy of the RHA delta limits shall be supplied.

5. PACKAGING

5.1 Packaging requirements. The requirements for packaging shall be in accordance with MIL-PRF-38535 for device

classes Q and V or MIL-PRF-38535, appendix A for device class M.

6. NOTES

6.1 Intended use. Microcircuits conforming to this drawing are intended for use for Government microcircuit applications

(original equipment), design applications, and logistics purposes.

6.1.1 Replaceability. Microcircuits covered by this drawing will replace the same generic device covered by a contractor

prepared specification or drawing.

6.1.2 Substitutability. Device class Q devices will replace device class M devices.

6.2 Configuration control of SMD's. All proposed changes to existing SMD's will be coordinated with the users of record for

the individual documents. This coordination will be accomplished using DD Form 1692, Engineering Change Proposal.

STANDARD

MICROCIRCUIT DRAWING

DEFENSE SUPPLY CENTER COLUMBUS

COLUMBUS, OHIO 43216-5000

DSCC FORM 2234

APR 97

SIZE

A

REVISION LEVEL

A

5962-94686

SHEET

10

Share Link: