LNK362 데이터 시트보기 (PDF) - Power Integrations, Inc
부품명
상세내역
제조사
LNK362 Datasheet PDF : 16 Pages
| |||
LNK362-364
TOP VIEW
Y1-
Capacitor
T
r
a
n
s
f
o
r
m
e
r
D
S
S
FB
S
S
BP
Opto-
coupler
Input Filter
Capacitor
HV DC
INPUT
CBP
Output Filter
Capacitor
DC
OUT
Maximize hatched copper
areas (
) for optimum
heatsinking
PI-4585-021607
Figure 7. Recommended Printed Circuit Layout for LinkSwitch-XT using D Package in a Flyback Converter Configuration.
capacitor should be minimized. In addition, sufficient copper
area should be provided at the anode and cathode terminals
of the diode for heat sinking. A larger area is preferred at the
quiet cathode terminal. A large anode area can increase high
frequency radiated EMI.
Quick Design Checklist
As with any power supply design, all LinkSwitch-XT designs
should be verified on the bench to make sure that component
specifications are not exceeded under worst-case conditions.The
following minimum set of tests is strongly recommended:
1. Maximum drain voltage – Verify that VDS does not exceed
650 V at the highest input voltage and peak (overload) output
power. The 50 V margin to the 700 V BVDSS specification
gives margin for design variation, especially in Clampless
designs.
2. Maximum drain current –At maximum ambient temperature,
maximum input voltage and peak output (overload) power,
verify drain current waveforms for any signs of transformer
saturation and excessive leading-edge current spikes at startup.
Repeat under steady state conditions and verify that the leading-
edge current spike event is below ILIMIT(MIN) at the end of the
t . LEB(MIN) Under all conditions, the maximum drain current
should be below the specified absolute maximum ratings.
3. Thermal Check – At specified maximum output power,
minimum input voltage and maximum ambient temperature,
verify that the temperature specifications are not exceeded
for LinkSwitch-XT, transformer, output diode and output
capacitors. Enough thermal margin should be allowed for
part-to-part variation of the RDS(ON) of LinkSwitch-XT as
specified in the data sheet. Under low line, maximum power,
a maximum LinkSwitch-XT SOURCE pin temperature of
105 °C is recommended to allow for these variations.
Design Tools
Up-to-date information on design tools can be found at the
Power Integrations web site: www.powerint.com.
27-7
Rev. E 11/08
Share Link: 