LT3013(RevC) 데이터 시트보기 (PDF) - Linear Technology

부품명

상세내역

제조사

LT3013
(Rev.:RevC)

250mA, 4V to 80V Low Dropout Micropower Linear Regulator with PWRGD

Linear Technology 

LT3013

APPLICATIONS INFORMATION

In situations where the ADJ pin is connected to a resistor

divider that would pull the ADJ pin above its 7V clamp volt-

age if the output is pulled high, the ADJ pin input current

must be limited to less than 5mA. For example, a resistor

divider is used to provide a regulated 1.5V output from the

1.24V reference when the output is forced to 60V. The top

resistor of the resistor divider must be chosen to limit the

current into the ADJ pin to less than 5mA when the ADJ

pin is at 7V. The 53V difference between the OUT and ADJ

pins divided by the 5mA maximum current into the ADJ

pin yields a minimum top resistor value of 10.6k.

In circuits where a backup battery is required, several

different input/output conditions can occur. The output

voltage may be held up while the input is either pulled

to ground, pulled to some intermediate voltage, or is left

open circuit. Current flow back into the output will follow

the curve shown in Figure 5. The rise in reverse output

current above 7V occurs from the breakdown of the 7V

clamp on the ADJ pin. With a resistor divider on the

regulator output, this current will be reduced depending

on the size of the resistor divider.

When the IN pin of the LT3013 is forced below the OUT

pin or the OUT pin is pulled above the IN pin, input cur-

rent will typically drop to less than 2μA. This can happen

if the input of the LT3013 is connected to a discharged

(low voltage) battery and the output is held up by either

a backup battery or a second regulator circuit. The state

of the ⎯S⎯H⎯D⎯N pin will have no effect on the reverse output

current when the output is pulled above the input.

200

TJ = 25°C

180 VIN = 0V

160 VOUT = VADJ

140

120

100 CURRENT FLOWS

INTO OUTPUT PIN

80

60

ADJ

PIN CLAMP

(SEE ABOVE)

40

20

0

0 1 2 3 4 5 6 7 8 9 10

OUTPUT VOLTAGE (V)

3013 F05

Figure 5. Reverse Output Current

3013fc

17

Share Link: