MCP73831T-5DCI 데이터 시트보기 (PDF) - Microchip Technology

부품명

상세내역

제조사

MCP73831T-5DCI

Miniature Single-Cell, Fully Integrated Li-Ion,Li-Polymer Charge Management Controllers

Microchip Technology 

4.5 Constant-Voltage Mode

When the voltage at the VBAT pin reaches the regula-

tion voltage, VREG, constant voltage regulation begins.

The regulation voltage is factory set to 4.2V, 4.35V,

4.40V, or 4.50V with a tolerance of ±0.75%.

4.6 Charge Termination

The charge cycle is terminated when, during Constant-

Voltage mode, the average charge current diminishes

below a percentage of the programmed charge current

(established with the value of the resistor connected to

the PROG pin). A 1 ms filter time on the termination

comparator ensures that transient load conditions do

not result in premature charge cycle termination. The

percentage or ratio of the current is factory set. Refer

to Section 1.0 “Electrical Characteristics” for

charge termination current options and the “Product

Identification System” for standard options.

The charge current is latched off and the MCP73831/2

enter a Charge Complete mode.

4.7 Automatic Recharge

The MCP73831/2 continuously monitor the voltage at

the VBAT pin in the Charge Complete mode. If the volt-

age drops below the recharge threshold, another

charge cycle begins and current is once again

supplied to the battery or load. The recharge threshold

is factory set. Refer to Section 1.0 “Electrical Char-

acteristics” for recharge threshold options and the

Product Identification System for standard options.

MCP73831/2

4.8 Thermal Regulation

The MCP73831/2 limit the charge current based on

the die temperature. The thermal regulation optimizes

the charge cycle time while maintaining device

reliability. Figure 4-2 depicts the thermal regulation for

the MCP73831/2.

525

450

RPROG = 2 kΩ

375

300

225

150

75

0

FIGURE 4-2:

Junction Temperature (°C)

Thermal Regulation.

4.9 Thermal Shutdown

The MCP73831/2 suspend charge if the die tempera-

ture exceeds 150°C. Charging will resume when the

die temperature has cooled by approximately 10°C.

© 2006 Microchip Technology Inc.

DS21984B-page 11

Share Link: