RT9502GQW 데이터 시트보기 (PDF) - Richtek Technology

부품명

상세내역

제조사

RT9502GQW

Linear Single Cell Li-Ion Battery Charger IC with Dual Input Supply

Richtek Technology 

RT9502

A

ITS

Temperature

Sense

TS

0.1uF to 10uF

VBATT

RT1

RT2

NTC

Battery

VTS

=

ITS

RT2 × (RT1 + RNTC )

RT1 + RT2 + RNTC

Turn off when VTS ≥ 2.5V or VTS ≤ 0.5V

Figure 3. Temperature Sensing Circuit

Fast-Charge Current Setting

Case 1 : ACIN Mode

The RT9502 offers ISETA pin to determine the ACIN charge

rate from 100mA to 1.2A. The charge current can be

calculated as following equation.

Icharge_ac

= KSET

VSET

RSETA

The parameter KSET = 300 ; VSET = 2.5V. RSETA is the

resistor connected between the ISETA and GND.

1200

1000

800

600

400

200

0

0.5 1.5 2.5 3.5 4.5 5.5 6.5 7.5 8.5 9.5

RRSSEETTAA(k(kΩ) )

Case 2 : USB Mode

When charging from a USB port, the ISETU pin can be

used to determine the charge current of 100mA or 500mA.

A low-level signal of ISETU pin sets the charge current at

100mA and a high level signal sets the charge current at

500mA.

Pre- Charge Current Setting

During a charge cycle if the battery voltage is below the

VPRECH threshold, the RT9502 applies a pre-charge

mode to the battery. This feature revives deeply discharged

cells and protects battery life. The RT9502 internal

determines the pre-charge rate as 10% of the fast-charge

current.

Battery Voltage Regulation

The RT9502 monitors the battery voltage through the BATT

pin. Once the battery voltage level closes to the VREG

threshold, the RT9502 voltage enters constant phase and

the charging current begins to taper down. When battery

voltage is over the VREG threshold, the RT9502 will stop

charge and keep to monitor the battery voltage. However,

when the battery voltage decreases 100mV below the

VREG, it will be recharged to keep the battery voltage.

Charge Status Outputs

The open-drain CHG_S and PGOOD outputs indicate

various charger operations as shown in the following table.

These status pins can be used to drive LEDs or

communicate to the host processor. Note that ON

indicates the open-drain transistor is turned on and LED

is bright.

Charge State

ACIN

Charge

Charge done

USB

Charge

Charge done

CHG_S

ON

OFF

ON

OFF

PGOOD

ON

ON

OFF

OFF

Figure 4. ACIN Mode Charge Current Setting

DS9502-02 April 2011

www.richtek.com

11

Share Link: