Q67121-C1007 데이터 시트보기 (PDF) - Siemens AG

부품명

상세내역

제조사

Q67121-C1007

16-Bit CMOS Single-Chip Microcontroller

Siemens AG 

1996 Intermediate Version

C161

Interrupt System

With an interrupt response time within a range from just 315 ns to 750 ns (in case of internal

program execution), the C161 is capable of reacting very fast to the occurence of non-deterministic

events.

The architecture of the C161 supports several mechanisms for fast and flexible response to service

requests that can be generated from various sources internal or external to the microcontroller. Any

of these interrupt requests can be programmed to being serviced by the Interrupt Controller or by

the Peripheral Event Controller (PEC).

In contrast to a standard interrupt service where the current program execution is suspended and

a branch to the interrupt vector table is performed, just one cycle is ‘stolen’ from the current CPU

activity to perform a PEC service. A PEC service implies a single byte or word data transfer between

any two memory locations with an additional increment of either the PEC source or the destination

pointer. An individual PEC transfer counter is implicity decremented for each PEC service except

when performing in the continuous transfer mode. When this counter reaches zero, a standard

interrupt is performed to the corresponding source related vector location. PEC services are very

well suited, for example, for supporting the transmission or reception of blocks of data. The C161

has 8 PEC channels each of which offers such fast interrupt-driven data transfer capabilities.

A separate control register which contains an interrupt request flag, an interrupt enable flag and an

interrupt priority bitfield exists for each of the possible interrupt sources. Via its related register, each

source can be programmed to one of sixteen interrupt priority levels. Once having been accepted

by the CPU, an interrupt service can only be interrupted by a higher prioritized service request. For

the standard interrupt processing, each of the possible interrupt sources has a dedicated vector

location.

Fast external interrupt inputs are provided to service external interrupts with high precision

requirements. These fast interrupt inputs feature programmable edge detection (rising edge, falling

edge or both edges).

Software interrupts are supported by means of the ‘TRAP’ instruction in combination with an

individual trap (interrupt) number.

The following table shows all of the possible C161 interrupt sources and the corresponding

hardware-related interrupt flags, vectors, vector locations and trap (interrupt) numbers:

Semiconductor Group

13

Share Link: