SP8713IGMPAS 데이터 시트보기 (PDF) - Mitel Networks
부품명
상세내역
제조사
SP8713IGMPAS Datasheet PDF : 9 Pages
| |||
SP8713
ABSOLUTE MAXIMUM RATINGS
Supply voltage (VEE=0V)
Control and RF inputs,
(note 1)
-0.5V to 7V
RF output (VEE =0V)
RF input current
(note 1) -0.5V to VCC+0.5V
(note 1)
10mA
Operating temperature
-40°C to +85°C
Storage temperature range
-55°C to +150°C
Maximum junction temperature
+150°C
NOTE 1. Duration <2 minutes.
ELECTRICAL CHARACTERISTICS
Guaranteed over the following conditions (unless otherwise stated):
VCC=+2.7V to +5.25V (with respect to VEE), Output load (pin 4) = 10pF, Tamb = -40°C to +85°C (note 2)
Characteristic
Min.
Value
Typ.
Max.
Units
Conditions
Supply current
(note 3)
4.1
4.7
mA Power down input low
Supply current
(note 3)
8
50
µA Power down input high
Power down high
Power down low
VCC-0.5
0
VCC
V
VCC-2.0
V
Modulus control 1 high
(note 4)
Modulus control 1 low
(note 4)
Modulus control 2 high
(note 4)
Modulus control 2 select low (note 4)
Max. sinewave input frequency
0.6VCC
0
0.6VCC
0
1100
VCC
0.4VCC
VCC
0.4VCC
V
V
V
V
MHz
Divide by 64 or 72
Divide by 65 or 72
Divide by 72
Divide by 64 or 65
See Figure 5
Min. sinewave input frequency
200
MHz See Figure 5
Min. RF input voltage
Max. RF input voltage
Output level (pin 4)
200
500
600
50 mV RMS RF input 200MHz to
1100MHz. See Figure 5
mV RMS RF input 200MHz to
1100MHz. See Figure 5
mV p-p
Modulus set-up time, ts
(notes 5,6,8)
20
Modulus hold time, th
(notes 6,8)
Power down time, tpd
(notes 7,8)
Power down recovery time, tpu(notes 7,8)
ns RF input = 1GHz
1
ns RF input = 1GHz
10
µs See Figure 9
6
µs See Figure 9
NOTES
2. All electrical testing is performed at +85°C.
3. Typical values are measured at +25°C and VCC = +5V.
4. Modulus Control and Ratio Select are high impedance inputs which can be driven directly by standard CMOS outputs.
5. Modulus control is latched at the end of the previous cycle.
6. See Figure 4.
7. See Figure 8.
8. These parameters are not tested but are guranteed by design.
2
Share Link: 