MX315A 데이터 시트보기 (PDF) - MX-COM Inc
부품명
상세내역
제조사
MX315A Datasheet PDF : 10 Pages
| |||
DATA BULLETIN
MX315A
CTCSS Encoder
Features
Field Programmable Tone
Encoder
40 CTCSS Frequencies
Crystal-Controlled Frequency
Stability
Low Distortion Sinewave Output
Few External Components
Required
CMOS Low Power Requirements
Applications
Mobile Radio Base Stations & Repeater
Stations
Mobile Radios
Hand-Held Radios
Industrial Controls
Intercom Systems
Door-Entry Systems
Xtal/Clock
Xtal
D0-D5
TX Enable
TX Enable
Clock
Generator
Binary
Rate
Multiplier
Programmed Clocks
TX Tone
Square
VDD
Wave
TX Tone
Sinewave
Output
Emitter
Follower
TX Tone Output
Enable
The MX315A is a monolithic CMOS tone encoder for sub-audible tone squelch systems, which provides three
additional frequencies over the earlier MX315A. These frequencies are 69.3, 97.4 and 206.5Hz. The tone
frequencies are derived from an input reference frequency. An on-chip inverter is provided to drive an
external crystal circuit.
Tone selection is achieved through six programming inputs and two control inputs (which allow either a logic
“1” or “0” to enable the device). A low distortion sinewave is generated at the TX Tone Output when the
MX315A is enabled. The emitter follower output stage can source 1mW directly into a 600 load (0dBm).
The MX315A is available in the following package styles: 16-pin SOIC (MX315ADW), 14-pin PDIP
(MX315AP) and 14-pin CDIP (MX315AJ).
1998 MXCOM, INC.
www.mxcom.com tel: 800 638 5577 336 744 5050 fax: 336 744 5054
Doc. # 20480054.006
4800 Bethania Station Road, Winston-Salem, NC 27105-1201 USA All Trademarks and service marks are held by there respective companies.
Share Link: 