MK10DN2M0VMD10 데이터 시트보기 (PDF) - Freescale Semiconductor

부품명

상세내역

제조사

MK10DN2M0VMD10

K10 Sub-Family

Freescale Semiconductor 

Peripheral operating requirements and behaviors

Table 15. MCG specifications (continued)

Symbol Description

tpll_lock Lock detector detection time

Min.

—

Typ.

—

Max.

150 × 10-6

+ 1075(1/

fpll_ref)

Unit

s

Notes

9

1. This parameter is measured with the internal reference (slow clock) being used as a reference to the FLL (FEI clock

mode).

2. These typical values listed are with the slow internal reference clock (FEI) using factory trim and DMX32=0.

3. The resulting system clock frequencies should not exceed their maximum specified values. The DCO frequency deviation

(Δfdco_t) over voltage and temperature should be considered.

4. These typical values listed are with the slow internal reference clock (FEI) using factory trim and DMX32=1.

5. The resulting clock frequency must not exceed the maximum specified clock frequency of the device.

6. This specification applies to any time the FLL reference source or reference divider is changed, trim value is changed,

DMX32 bit is changed, DRS bits are changed, or changing from FLL disabled (BLPE, BLPI) to FLL enabled (FEI, FEE,

FBE, FBI). If a crystal/resonator is being used as the reference, this specification assumes it is already running.

7. Excludes any oscillator currents that are also consuming power while PLL is in operation.

8. This specification was obtained using a Freescale developed PCB. PLL jitter is dependent on the noise characteristics of

each PCB and results will vary.

9. This specification applies to any time the PLL VCO divider or reference divider is changed, or changing from PLL disabled

(BLPE, BLPI) to PLL enabled (PBE, PEE). If a crystal/resonator is being used as the reference, this specification assumes

it is already running.

6.3.2 Oscillator electrical specifications

This section provides the electrical characteristics of the module.

6.3.2.1 Oscillator DC electrical specifications

Table 16. Oscillator DC electrical specifications

Symbol

VDD

IDDOSC

Description

Supply voltage

Supply current — low-power mode (HGO=0)

• 32 kHz

• 4 MHz

• 8 MHz (RANGE=01)

• 16 MHz

• 24 MHz

• 32 MHz

Min.

1.71

—

—

—

—

—

—

Typ.

—

500

200

300

950

1.2

1.5

Max.

3.6

—

—

—

—

—

—

Unit

Notes

V

1

nA

μA

μA

μA

mA

mA

Table continues on the next page...

K10 Sub-Family Data Sheet, Rev. 3, 6/2013.

Freescale Semiconductor, Inc.

29

Share Link: