T55B227M004C0055 데이터 시트보기 (PDF) - Vishay Semiconductors
부품명
상세내역
제조사
T55B227M004C0055
Vishay Semiconductors
T55B227M004C0055 Datasheet PDF : 25 Pages
| |||
www.vishay.com
T55
Vishay Polytech
PERFORMANCE CHARACTERISTICS
ITEM
CONDITION
POST TEST PERFORMANCE
Specified
initial value
-55 °C
+105 °C
Capacitance change
-
-30 % to 0 % 0 % to +50 %
Temperature Measure the specified
characteristics characteristics in each stage
Dissipation factor
shown in Standard 8 to 10
14
-
Ratings table or less
Leakage current
Refer to
Standard
Ratings
table
Not more than
-
1 CV or 30 μA
which is greater
105 °C, 1000 successive test cycles in series with
a 1 k resistor at the rate of 30 s ON,
30 s OFF; test voltage per table below:
Capacitance change Within ± 20 % of initial value
Surge voltage
Rated
voltage
2.5
4.0
6.3
7.0
10
12.5
16
20
25
35
50
63
Dissipation factor
Within initial limit
Surge
voltage
3.2
5.2
8.2
9.0 13
16.2 20 23 29 40 57 72
Leakage current
Shall not exceed 300 % of initial limit
Solder heat
resistance
Reflow board surface peak temperature:
less than 260 °C
Time: 5 s max.
Capacitance change Within ± 20 % of initial value
Dissipation factor Initial specified value or less
Leakage current Shall not exceed 300 % of initial specified value
Moisture
resistance
no load
Leave at 60 °C and 90 % RH for 500 h
VR 4 V
Capacitance change
VR 6.3 V
Relative to the value before test
+50 % to -20 %
Relative to the value before test
+40 % to -20 %
Dissipation factor Initial specified value or less
Leakage current Shall not exceed 300 % of initial specified value
High
temperature
load
105 °C. The rated voltage is applied through a
protective resistor of 3 for 1000 h or 2000 h (1)
Capacitance change Within ± 20 % of initial value
Dissipation factor Initial specified value or less
Leakage current Shall not exceed 300 % of initial specified value
Leave at -55 °C, normal temperature, 105 °C,
Thermal shock
and normal temperature for 30 min., 15 min.
30 min., and 15 min.
Repeat this operation 5 times running.
Capacitance change Within ± 20 % of initial value or less
Dissipation factor Initial specified value or less
Leakage current Shall not exceed 300 % of initial specified value
Failure rate
105 °C. The rated voltage is applied through
a protective resistor of 1 /V.
1 % / 1000 h
Notes
• Test conditions per JIS C5101-1
(1) Test time, please refer to table “Standard Ratings”
Revision: 26-Oct-2018
13
Document Number: 40174
For technical questions, contact: polytech@vishay.com
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
Share Link: 