AZ765
SPST SUBMINIATURE
POWER RELAY
FEATURES
• Small footprint
• Low cost
• Epoxy sealed version available
• 10 Amp switching
• UL, CUR File E43203
CONTACTS
Arrangement
SPST (1 Form A)
SPDT (1 Form C)
Ratings
Resistive load:
Max. switched power: 280 W or 1200 VA
Max. switched current: 10 A
Max. switched voltage: 150* VDC or 400 VAC
*Note: If switching voltage is greater than 30 VDC,
special precautions must be taken.
Please contact the factory.
Rated Load
UL, CUR
10 A at 120 VAC
10 A at 28 VDC
Material
Silver cadmium oxide
Resistance
< 50 milliohms initially
(24 V, 1 A voltage drop method)
COIL
Power
At Pickup Voltage
(typical)
Max. Continuous
Dissipation
Temperature Rise
Temperature
253 mW
1.1 W at 20°C (68°F) ambient
42°C (76°F) at nominal coil voltage
Max. 105°C (221°F)
GENERAL DATA
Life Expectancy
Mechanical
Electrical
Minimum operations
1 x 107
1 x 105 at 10 A 120 VAC Res.
Operate Time (typical) 8 ms at nominal coil voltage
Release Time (typical) 5 ms at nominal coil voltage
(with no coil suppression)
Dielectric Strength
2500 Vrms coil to contact
(at sea level for 1 min.) 1000 Vrms between open contacts
Insulation
Resistance
1000 megohms min. at 20°C
500 VDC 50% RH
Dropout
Greater than 5% of nominal coil voltage
Ambient Temperature At nominal coil voltage
Operating
-40°C (-40°F) to 65°C (149°F)
Storage
-40°C (-40°F) to 105°C (221°F)
Vibration
0.040" (1.5 mm) DA at 10–50 Hz
Shock
10 g operating, 100 g damage
Enclosure
P.B.T. polyester
Terminals
Tinned copper alloy, P. C.
Max. Solder Temp.
270°C (518°F)
Max. Solder Time
5 seconds
Max. Solvent Temp. 80°C (176°F)
Max. Immersion Time 30 seconds
Weight
6 grams
NOTES
1. All values at 20°C (68°F).
2. Relay may pull in with less than “Must Operate” value.
3. Specifications subject to change without notice.
ZETTLER electronics GmbH
Junkersstrasse 3, D-82178 Puchheim, Germany
Tel. +49 89 800 97 0
Fax +49 89 800 97 200
office@ZETTLERelectronics.com
www.ZETTLERelectronics.com
2003-06-30