DS1305E View Datasheet(PDF) - Dallas Semiconductor -> Maxim Integrated

Part Name

Description

Manufacturer

DS1305E

Serial Alarm Real Time Clock (RTC)

Dallas Semiconductor -> Maxim Integrated 

STATUS REGISTER (READ 10H)

BIT7

BIT6

BIT5

BIT4

0

0

0

0

BIT3

0

BIT2

0

BIT1

IRQF1

DS1305

BIT0

IRQF0

IRQF0 (Interrupt 0 Request Flag) - A logic 1 in the Interrupt Request Flag bit indicates that the current

time has matched the Alarm 0 registers. If the AIE0 bit is also a logic 1, the INT0 pin will go low.

IRQF0 is cleared when any of the Alarm 0 registers are read or written.

IRQF1 (Interrupt 1 Request Flag) - A logic 1 in the Interrupt Request Flag bit indicates that the current

time has matched the Alarm 1 registers. This flag can be used to generate an interrupt on either INT0 or

INT1 depending on the status of the INTCN bit in the Control Register. If the INTCN bit is set to a logic

1 and IRQF1 is at a logic 1 (and AIE1 bit is also a logic 1), the INT1 pin will go low. If the INTCN bit is

set to a logic 0 and IRQF1 is at a logic 1 (and AIE1 bit is also a logic 1), the INT0 pin will go low.

IRQF1 is cleared when any of the Alarm 1 registers are read or written.

TRICKLE CHARGE REGISTER (READ 11H, WRITE 91H)

This register controls the trickle charge characteristics of the DS1305. The simplified schematic of

Figure 4 shows the basic components of the trickle charger. The trickle charge select (TCS) bits (bits

4-7) control the selection of the trickle charger. In order to prevent accidental enabling, only a pattern of

1010 will enable the trickle charger. All other patterns will disable the trickle charger. The DS1305

powers up with the trickle charger disabled. The diode select (DS) bits (bits 2-3) select whether one

diode or two diodes are connected between VCC1 and VCC2 . If DS is 01, one diode is selected. If DS is

10, two diodes are selected. If DS is 00 or 11, the trickle charger is disabled independent of TCS. The

RS bits select the resistor that is connected between VCC1 and VCC2. The resistor is selected by the resister

select (RS) bits as shown in Table 2.

PROGRAMMABLE TRICKLE CHARGER Figure 4

8 of 22

Share Link: