MINI51 View Datasheet(PDF) - Unspecified
Part Name
Description
Manufacturer
MINI51 Datasheet PDF : 342 Pages
| |||
NuMicro™ Mini51 Technical Reference Manual
Supports external trigger in Pulse Width Measurement mode
Supports external trigger in Pulse Width Capture mode
Watchdog Timer
Programmable clock source and time-out period
Supports wake-up function in Power-down mode and Idle mode
Interrupt or reset selectable when time-out happens
PWM
Up to three built-in 16-bit PWM generators with six PWM outputs or three
complementary paired PWM outputs
Supports edge alignment or center alignment
Supports fault detection
Individual clock source, clock divider, 8-bit prescalar and dead-zone generator for
each PWM generator
PWM interrupt synchronized to PWM period
UART (Universal Asynchronous Receiver/Transmitters)
One UART device
Buffered receiver and transmitter with 16-byte FIFO
Optional flow control function (CTSn and RTSn)
Supports IrDA (SIR) function
Programmable baud-rate generator up to 1/16 system clock
Supports RS-485 function
SPI (Serial Peripheral Interface)
One SPI device
Masters up to 12 MHz, and Slaves up to 4 MHz
Supports SPI Master/Slave mode
Full duplex synchronous serial data transfer
Variable length of transfer data from 1 to 32 bits
MSB or LSB first data transfer
Rx and Tx on both rising or falling edge of serial clock independently
Byte Suspend mode in 32-bit transmission
I2C
Supports Master/Slave mode
Bi-directional data transfer between masters and slaves
Multi-master bus (no central master)
Arbitration between simultaneously transmitting masters without corruption of
serial data on the bus
Serial clock synchronization allowing devices with different bit rates to
Feb 9, 2012
Page 12 of 342
Revision V1.03
Share Link: 