IT8518F View Datasheet(PDF) - ITE Tech. INC.
Part Name
Description
Manufacturer
IT8518F Datasheet PDF : 44 Pages
| |||
Safety Summary
The following general safety precautions must be observed during all phases of operation
of this instrument. Failure to comply with these precautions or with specific warnings
elsewhere in this manual violates safety standards of design, manufacture, and intended
use of the instrument .We assumes no liability for the customer’s failure to comply with these
requirements.
Environmental Conditions
This instrument is intended for indoor use. Pollution degree 2 environments. It is designed to
operate at a maximum relative humidity of 95% and at altitudes of up to 2000 meters. Refer
to the specifications tables for the ac mains voltage requirements and ambient operating
temperature range.
Before Applying Power
Verify that all safety precautions are taken. Note the instrument's external markings
described under "Safety Symbols".
Ground the Instrument
This product is a Safety Class 1 instrument (provided with a protective earth terminal). To
minimize shock hazard, the instrument chassis and cover must be connected to an electrical
ground. The instrument must be connected to the ac power mains through a grounded
power cable, with the ground wire firmly connected to an electrical ground (safety ground)
at the power outlet. Note: Any interruption of the protective (grounding) conductor or
disconnection of the protective earth terminal will cause a potential shock hazard that could
result in personal injury.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the instrument in the presence of fumes or flammable gases.
KEEP AWAY FROM LIVE CIRCUITS
Operating personnel must not remove instrument covers except as instructed in this Guide
for installing or removing electronic load modules. Component replacement and internal
adjustments must be made only by qualified service personnel. Do not replace components
with power cable connected. Under certain conditions dangerous voltages may exist even
with the power cable removed. To avoid injuries always disconnect power, discharge circuits,
and remove external voltage sources before touching components.
USER’S GUIDE 5
Share Link: 