ATF22LV10C-15PI View Datasheet(PDF) - Atmel Corporation
Part Name
Description
Manufacturer
ATF22LV10C-15PI Datasheet PDF : 19 Pages
| |||
Atmel ATF22LV10C
2. Absolute Maximum Ratings*
Temperature Under Bias .................. -40°C to +85°C
Storage Temperature...................... -65°C to +150°C
Voltage on Any Pin with
Respect to Ground...........................-2.0V to +7.0V(1)
Voltage on Input Pins
with Respect to Ground
During Programming......................-2.0V to +14.0V(1)
Programming Voltage with
Respect to Ground.........................-2.0V to +14.0V(1)
*NOTICE:
Stresses beyond those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only and functional operation of the
device at these or any other conditions beyond those indi-
cated in the operational sections of this specification is not
implied. Exposure to absolute maximum rating conditions
for extended periods may affect device reliability.
Note:
1. Minimum voltage is -0.6V DC, which may undershoot to -
2.0V for pulses of less than 20ns. Maximum output pin volt-
age is VCC + 0.75V DC, which may overshoot to 7.0V for
pulses of less than 20ns.
3. DC and AC Operating Conditions
Operating Temperature (Ambient)
VCC Power Supply
Commercial
0°C - 70°C
3.0V - 5.5V
Industrial
-40°C - 85°C
3.0V - 5.5V
3.1 DC Characteristics
Symbol Parameter
Condition(2)
Min
Typ
Max
IIL
Input or I/O Low Leakage Current
0 VIN VIL(Max)
IIH
Input or I/O High Leakage Current (VCC - 0.2)V VIN VCC
ICC
Power Supply Current
VCC = Max, VIN = Max
Outputs Open
Com.
Ind.
-10
10
55
85
60
90
ICC2
Clocked Power Supply Current
VCC = Max
Outputs Open, f = 15MHz
Com.
Ind.
100
105
IPD
IOS(1)
VIL
VIH
VOL
VOH
VOH
Notes:
Power Supply Current,
Power-down Mode
Output Short Circuit Current
Input Low Voltage
VCC = 3.6V, Max
VIN = 0, Outputs Open
VOUT = 0.5V
Com.
Ind.
10
100
10
120
-130
-0.5
0.8
Input High Voltage
2.0
VCC + 0.75
VIN = VIH or VIL
Output Low Voltage
VCC = Min
0.5
IOL = 16mA
VIN = VIH or VIL
Output High Voltage
VCC = Min
2.4
IOH = -2.0mA
Output High Voltage
IOH = -100µA
VCC - 0.2V
1. Not more than one output at a time should be shorted. Duration of short circuit test should not exceed 30 sec
2. For DC characteristics, the test condition of VCC = Max corresponds to 3.6V
Units
µA
µA
mA
mA
mA
mA
µA
µA
mA
V
V
V
V
V
3
0780M–PLD–7/10
Share Link: 