CC2430
7.11 Control AC Characteristics
TA= -40°C to 85°C, VDD=2.0V to 3.6V if nothing else stated.
Table 15: Control Inputs AC Characteristics
Parameter
Min
Typ
Max Unit
Condition/Note
System clock,
16
fSYSCLK
tSYSCLK= 1/ fSYSCLK
RESET_N low
250
width
Interrupt pulse
width
tSYSCLK
32 MHz
ns
ns
System clock is 32 MHz when crystal oscillator is used.
System clock is 16 MHz when calibrated 16 MHz RC
oscillator is used.
See item 1, Figure 1. This is the shortest pulse that is
guaranteed to be recognized as a complete reset pin
request. Note that shorter pulses may be recognized but
will not lead to complete reset of all modules within the
chip.
See item 2, Figure 1.This is the shortest pulse that is
guaranteed to be recognized as an interrupt request. In
PM2/3 the internal synchronizers are bypassed so this
requirement does not apply in PM2/3.
1
RESET_N
Px.n
2
2
Px.n
Figure 1: Control Inputs AC Characteristics
CC2430 Data Sheet (rev. 2.1) SWRS036F
Page 18 of 211