S-24CS01AFJ-TB View Datasheet(PDF) - Seiko Instruments Inc

Part Name

Description

Manufacturer

S-24CS01AFJ-TB

(S-24CS0xA) 2-Wire CMOS Serial E2PROM

Seiko Instruments Inc 

Rev.4.4_00

2-WIRE CMOS SERIAL E2PROM

S-24CS01A/02A/04A/08A

7. 2 Random Read

Random read is used to read the data at an arbitrary memory address.

A dummy write is performed to load the memory address into the address counter.

When the E2PROM receives a 7-bit device address and a 1-bit read / write instruction code set to "0"

following a start condition, it responds with an acknowledge. The E2PROM then receives an 8-bit word

address and responds with an acknowledge. The memory address is loaded to the address counter in the

E2PROM by these operations. Reception of write data does not follow in a dummy write whereas reception

of write data follows in a byte write and in a page write.

Since the memory address is loaded into the memory address counter by dummy write, the master device

can read the data starting from the arbitrary memory address by transmitting a new start condition and

performing the same operation in the current address read.

That is, when the E2PROM receives a 7-bit device address and a 1-bit read / write instruction code set to

"1", following a start condition signal, it responds with an acknowledge. Next, 8-bit data is transmitted from

the E2PROM in synchronous to the SCL clock. The master device outputs stop condition not an

acknowledge , the reading of E2PROM is ended.

SDA

LINE

S

W

T

R

A

I

R

DEVICE T

T

ADDRESS E

S

T

A

WORD

R

ADDRESS (n)

T

R

E

DEVICE A

ADDRESS D

NO ACK from

S

Master Device

T

O

DATA

P

1 0 1 0 A2 A1 A0 0 W7W6W5W4W3W2W1W0

M

L RA

A

S

S /C

C

B

B WK

K

1 0 1 0 A2 A1 A0 1 D7 D6 D5 D4 D3 D2 D1 D0

M

LR A

S

S/ C

B

BWK

ADR INC

DUMMY WRITE

Remark1. A1 is P1 in the S-24CS08A.

2. A0 is P0 in the S-24CS04A/08A.

3. W7 is optional in the S-24CS01A.

Figure 17 Random Read

Seiko Instruments Inc.

17

Share Link: