ICPL0600 View Datasheet(PDF) - Isocom

Part Name

Description

Manufacturer

ICPL0600

Infrared emitting diode, optically coupled to a high speed integrated photo detector logic gate with a strobable output

Isocom  

ISOCOM

COMPONENTS

ICPL0600 / ICPL0601 / ICPL0611

Notes:

- The VCC supply must be bypassed by a 0.1μF capacitor or larger with good high frequency characteristic and

should be connected as close as possible to the package VCC and GND pins.

- Enable Input – No pull up resistor required as the device has an internal pull up resistor.

- tPLH is measured from the 3.75mA level on the HIGH to LOW transition of the input current pulse to the 1.5 V

level on the LOW to HIGH transition of the output voltage pulse.

- tPHL is measured from the 3.75mA level on the LOW to HIGH transition of the input current pulse to the 1.5 V

level on the HIGH to LOW transition of the output voltage pulse.

- tr Rise time is measured from the 10% to the 90% levels on the LOW to HIGH transition of the output pulse.

- tf Fall time is measured from the 90% to the 10% levels on the HIGH to LOW transition of the output pulse.

- tELH is measured from the 1.5V level on the HIGH to LOW transition of the input Enable voltage pulse to the

1.5V level on the LOW to HIGH transition of the output voltage pulse.

- tEHL is measured from the 1.5V level on the LOW to HIGH transition of the input Enable voltage pulse to the

1.5V level on the HIGH to LOW transition of the output voltage pulse.

- CMH– The maximum tolerable rate of rise of the common mode voltage to ensure the output will remain in the

HIGH state (i.e., VO > 2.0V).

- CML– The maximum tolerable rate of rise of the common mode voltage to ensure the output will remain in the

LOW output state (i.e., VO < 0.8V).

9 5/12/2012

DC93162

Share Link: