VND810SP View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

VND810SP

DOUBLE CHANNEL HIGH SIDE DRIVER

STMicroelectronics 

VND810SP

µC I/Os PROTECTION:

If a ground protection network is used and negative

transient are present on the VCC line, the control pins will

be pulled negative. ST suggests to insert a resistor (Rprot)

in line to prevent the µC I/Os pins to latch-up.

The value of these resistors is a compromise between

the leakage current of µC and the current required by the

HSD I/Os (Input levels compatibility) with the latch-up limit

of µC I/Os.

-VCCpeak/Ilatchup ≤ Rprot ≤ (VOHµC-VIH-VGND) / IIHmax

Calculation example:

For VCCpeak= - 100V and Ilatchup ≥ 20mA; VOHµC ≥ 4.5V

5kΩ ≤ Rprot ≤ 65kΩ.

Recommended Rprot value is 10kΩ.

OPEN LOAD DETECTION IN OFF STATE

Off state open load detection requires an external pull-up

resistor (RPU) connected between OUTPUT pin and a

positive supply voltage (VPU) like the +5V line used to

supply the microprocessor.

The external resistor has to be selected according to the

following requirements:

1) no false open load indication when load is connected:

in this case we have to avoid VOUT to be higher than

VOlmin; this results in the following condition

VOUT=(VPU/(RL+RPU))RL<VOlmin.

2) no misdetection when load is disconnected: in this

case the VOUT has to be higher than VOLmax; this

results in the following condition RPU<(VPU–VOLmax)/

IL(off2).

Because Is(OFF) may significantly increase if Vout is pulled

high (up to several mA), the pull-up resistor RPU should

be connected to a supply that is switched OFF when the

module is in standby.

The values of VOLmin, VOLmax and IL(off2) are available in

the Electrical Characteristics section.

Open Load detection in off state

INPUT

STATUS

V batt.

VPU

VCC

RPU

DRIVER

+

LOGIC

IL(off2)

+

R

-

OUT

VOL

RL

GROUND

9/18

1

Share Link: