C8051F97X View Datasheet(PDF) - Silicon Laboratories
Part Name
Description
Manufacturer
C8051F97X Datasheet PDF : 455 Pages
| |||
Register 33.9. PCA0CPM1: PCA Channel 1 Capture/Compare Mode
Bit
7
6
5
4
3
2
1
0
Name PWM16 ECOM
CAPP
CAPN
MAT
TOG
PWM
ECCF
Type
RW
RW
RW
RW
RW
RW
RW
RW
Reset
0
0
0
0
0
0
0
0
SFR Page = 0x0; SFR Address: 0xDB
Table 33.12. PCA0CPM1 Register Bit Descriptions
Bit
Name
Function
7
PWM16 Channel 1 16-bit Pulse Width Modulation Enable.
This bit enables 16-bit mode when Pulse Width Modulation mode is enabled.
0: 8 to 11-bit PWM selected.
1: 16-bit PWM selected.
6
ECOM Channel 1 Comparator Function Enable.
This bit enables the comparator function.
5
CAPP Channel 1 Capture Positive Function Enable.
This bit enables the positive edge capture capability.
4
CAPN Channel 1 Capture Negative Function Enable.
This bit enables the negative edge capture capability.
3
MAT Channel 1 Match Function Enable.
This bit enables the match function. When enabled, matches of the PCA counter with a
module's capture/compare register cause the CCF1 bit in the PCA0MD register to be set
to logic 1.
2
TOG Channel 1 Toggle Function Enable.
This bit enables the toggle function. When enabled, matches of the PCA counter with the
capture/compare register cause the logic level on the CEX1 pin to toggle. If the PWM bit
is also set to logic 1, the module operates in Frequency Output Mode.
1
PWM Channel 1 Pulse Width Modulation Mode Enable.
This bit enables the PWM function. When enabled, a pulse width modulated signal is out-
put on the CEX1 pin. 8 to 11-bit PWM is used if PWM16 is cleared to 0; 16-bit mode is
used if PWM16 is set to 1. If the TOG bit is also set, the module operates in Frequency
Output Mode.
0
ECCF Channel 1 Capture/Compare Flag Interrupt Enable.
This bit sets the masking of the Capture/Compare Flag (CCF1) interrupt.
0: Disable CCF1 interrupts.
1: Enable a Capture/Compare Flag interrupt request when CCF1 is set.
441
Rev 1.1
Share Link: 