S25FL129P View Datasheet(PDF) - Spansion Inc.
Part Name
Description
Manufacturer
S25FL129P Datasheet PDF : 69 Pages
| |||
Data Sheet
3. Input/Output Descriptions
Signal
SO/IO1
SI/IO0
SCK
CS#
HOLD#/IO3
W#/ACC/IO2
VCC
GND
I/O
I/O
I/O
Input
Input
I/O
I/O
Input
Input
Description
Serial Data Output: Transfers data serially out of the device on the falling edge of SCK.
Functions as an I/O pin in Dual and Quad I/O, and Quad Page Program modes.
Serial Data Input: Transfers data serially into the device. Device latches commands,
addresses, and program data on SI on the rising edge of SCK. Functions as an I/O pin in Dual
and Quad I/O mode.
Serial Clock: Provides serial interface timing. Latches commands, addresses, and data on SI on
rising edge of SCK. Triggers output on SO after the falling edge of SCK.
Chip Select: Places device in active power mode when driven low. Deselects device and places
SO at high impedance when high. After power-up, device requires a falling edge on CS# before
any command is written. Device is in standby mode when a program, erase, or Write Status
Register operation is not in progress.
Hold: Pauses any serial communication with the device without deselecting it. When driven low,
SO is at high impedance, and all input at SI and SCK are ignored. Requires that CS# also be
driven low. Functions as an I/O pin in Quad I/O mode.
Write Protect: Protects the memory area specified by Status Register bits BP2:BP0. When
driven low, prevents any program or erase command from altering the data in the protected
memory area. Functions as an I/O pin in Quad I/O mode.
Supply Voltage
Ground
4. Logic Symbol
VCC
SI/IO0
SCK
CS#
W#/ACC/IO2
HOLD#/IO3
GND
SO/IO1
September 21, 2012 S25FL129P_00_08
S25FL129P
11
Share Link: 